User manual ROTEL RCD-06 SE

[. . . ] WARNING: To reduce the risk of fire or electric shock, do not exposetheunittomoistureorwater. Iftheunitisexposedtomoisture, oraforeignobject gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. [. . . ] Through out this manual the items refered to in the text are identified by the corresponding call out. The items on the front and rear panels are identified with a number call out, such a 1. The items on the remote control are labeled with a letter call out, such as A. [See Figure 3 for wiring illustration] A pair of standard RCA jacks supplies an analog output signal from the RCD-06 SE to the source inputs of an audio preamplifier, integrated amplifier, or receiver. Connect the left channel output of the RCD-06 SE to the left channel source input on the preamplifier or other component. Your RCD-06 SE is configured at the factory for the proper AC voltage in the country where you purchased it (either 120 volts or 230 volts). Note: Should you move your CD player to another country, it may be Possible to reconfigure it for use on a different line voltage. Opening the enclosure of the RCD-06 SE exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. [See Figure 4 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-06 SE, taken before the built-in D/A converter. The RCD-06 SE can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. Pressing the STOP button twice quickly in succession cancels any programmed selections (see below). Before using the IR remote control, it is necessary to install two "UM-4/ AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR sensor Display area on the front panel of the RCD-06 SE. The disc continues to spin and play will be resumed from the current position. To resume playing the disc, press the PAUSE button again or press the PLAY button. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. Pressing the left TRACK button returns to the beginning of the current track. Pressing twice quickly in succession returns to the beginning of the previous track. [. . . ] Pressing the button a second time displays the time remaining on the entire disc (or memorized program). 5 mm mini-jack (labeled EXT REM IN) receives command codes from an industry-standard infrared receiver (Xantech, etc. This feature is useful when the unit is installed in a cabine and the front-panel sensor is blocked. Consul your authorized Rotel dealer for information on external receivers and the proper wiring o a jack to fit the mini-jack receptacle. [. . . ]