User manual ROTEL RCD-1070

[. . . ] WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. [. . . ] Connect the left and right channel outputs of the RCD-1072 to the corresponding inputs on the preamplifier or other component. Before using the IR remote control, it is necessary to install two "UM-4/AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR located in the lower left corner of sensor the RCD-1072 front panel. If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-1072. A lighted Display on the front panel of the RCD-1072 provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. The LED indicator above the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the 12V input and a trigger signal is present, the RCD-1072 is activated. When the trigger signal is turned off, the unit goes into standby mode. The front panel power indicator remains lit, but the display goes dark and the unit will not operate. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. NOTE: When using the 12V Trigger feature, leave the POWER button in the ON position. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. If there are more than 16 tracks on the disc, all of the digits will light accompanied by the word OVER, regardless of which track is playing. This matrix is independent of the main numeric area of the Display, which will always indicate the currently playing track, even if above 16. The DIRECT ACCESS buttons may also be used to memorize tracks in PROGRAM mode (see PROGRAM Button section). A motor-driven disc drawer, located in the center of the RCD-1072, slides out to accept a compact disc and retracts to play the disc. The drawer can be closed in two ways: pushing the OPN/CLS button or pushing the PLAY button. [. . . ] This button, labeled REPT allows you to repeat the current track or the entire disc continuously until the feature is cancelled by disengaging the REPEAT button or pressing STOP. Press the button once and the RCD-1072 will repeat just the current track, displaying the indicators REPEAT 1 in the Display. Press the button a second time and the RCD-1072 will repeat the entire disc, displaying REPEAT ALL in the Display. As noted above, REPEAT can be used in conjunction with the RANDOM play feature. [. . . ]