User manual ROTEL RCD-820

[. . . ] Heed all warnings and safety information in these instructions and on the product itself. You must allow 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation slots. If the component is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling. [. . . ] Opening the enclosure of the RCD-820 exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. The RCD-820 should be plugged directly into a 2-pin polarized wall outlet or into the switched outlet on another component in your audio system. Be sure the power switch on the front panel of the RCD-820 is turned off (in the "out" position). Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a month-long vacation, it is a sensible precaution to unplug your CD player (as well as other audio and video components) while you are away. The RCD-820 gives you a choice of two different kinds of output connections -- an analog output signal from the built-in D/A converter for use with conventional analog audio components and a coax digital output which provides an unprocessed digital data signal for use with outboard D/A converters or digital processors. NOTE: To prevent loud noises that neither you nor your speakers will appreciate, make sure the CD player is turned off when you make any signal connections. The RCD-820 can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. The first ten tracks on a disc can be selected by pressing the corresponding button. For example, to play the third track, press the 3 button on the remote control. When accessing track numbers greater than 10, press the>10 button followed by the track number. For example, to select track 12, press the >10 button followed by the 1 button and then the 2 button. The number of the selected track will appear in the main numeric area at the center of the Display. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. If there are more than 16 tracks on the disc, all of the digits will light accompanied by the word OVER, regardless of which track is playing. This matrix is independent of the main numeric area of the Display, which will always indicate the currently playing track, even if above 16. The DIRECT ACCESS buttons may also be used to memorize tracks in PROGRAM mode (see below). Remote Only This button, labeled PROG, allows you to memorize as many as 20 tracks on the current disc for playback in a specific order. For example, you could instruct the RCD-820 to play track 5, followed by track 3, followed by track 8. [. . . ] When the trigger signal is interrupted, the unit goes into standby mode. The front panel indicator light remains lit, but the display goes dark and the unit will not operate. NOTE: When using the 12V Trigger feature, leave the POWER button in the ON position. Remote Only This button allows you to remove a track selection from the memorized program play list during the review procedure described above. [. . . ]