User manual ROTEL RCD-820BX

[. . . ] Heed all warnings and safety information in these instructions and on the product itself. You must allow 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation slots. If the component is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling. [. . . ] Opening the enclosure of the RCD-1072 exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. The RCD-1072 should be plugged directly into a 2-pin polarized wall outlet or into the switched outlet on another component in your audio system. Be sure the power switch on the front panel of the RCD-1072 is turned off (in the "out" position). Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a monthlong vacation, it is a sensible precaution to unplug your CD player (as well as other audio and video components) while you are away. Note: To prevent loud noises that could damage your speakers, turn off all the system components when you make any signal connections. The RCD-1072 can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. A pair of standard RCA jacks supplies an analog output signal from the RCD-1072 to the source inputs of an audio preamplifier, integrated amplifier, or receiver. The disc continues to spin and play will be resumed from the current position. To resume playing the disc, press the PAUSE button again or press the PLAY button. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. Pressing the left TRACK button returns to the beginning of the current track. Pressing twice quickly in succession returns to the beginning of the previous track. These buttons are also used to select a track before pressing the PLAY button or when memorizing tracks for the PROGRAM play mode (see below). These selections are made by continuously pressing the TRACK buttons until the desired track is reached. Except where noted, all functions are available on the RCD-1072 front panel and the IR remote control. These buttons fast forward or fast reverse through the currently playing disc as long as they are pressed. When the transport disc drawer is closed, pressing this button automatically opens the drawer. The drawer can also be closed by pressing the PLAY button When the drawer is open, the Display will read "OPEN". [. . . ] Pressing the REVIEW button again while the track number is flashing will continue the review sequence, showing the next memorized track. Continue pressing the REVIEW button to see the complete memorized track list. If you do not press the REVIEW button while the track number is flashing, the review process is terminated and the unit resumes whatever mode it was in before you started to review, except that the last reviewed track number will remain active and shown in the display. Note that you may remove a selection from the play list during the review procedure using the CLEAR button, as described below. [. . . ]