User manual ROTEL RCD-930AX

[. . . ] Heed all warnings and safety information in these instructions and on the product itself. You must allow a minimum 10 cm or 4 inches of unobstructed clearance around the unit. The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to be left unused for a long period of time. Use only with a cart, stand, rack, bracket or shelf system recommended by Rotel. [. . . ] When AC power is applied to the unit, it will power up in fully active mode. The RCD-930AX gives you a choice of two different kinds of output connections--an analog output signal from the built-in D/A converter for use with conventional analog audio components and a coax digital output which provides an unprocessed digital data signal for use with outboard D/A converters or digital processors. Use common sense when placing the RCD-930AX in a cabinet or when stacking other equipment. Avoid placing the unit where it may be subject to excessive heat such as on top of a large power amplifier or near a heat register. For best performance, avoid placing the unit where it may be subject to vibration, such as near a speaker. Note: To prevent loud noises that neither you nor your speakers will appreciate, make sure the CD player is turned off when you make any signal connections. This manual shows illustrations of the front and rear panels and the RRD95 remote control. Each item in the illustrations is identified with a call out in a gray box. Through out this manual the items refered to in the text are identified by the corresponding call out. The items on the front and rear panels are identified with a number call out, such a 1. The items on the remote control are labeled with a letter call out, such as A. Each of these indicators is described in the detailed operating instructions that follow. A motor-driven disc drawer, located in the center of the RCD-930AX, slides out to accept a compact disc and retracts to play the disc. The drawer can be closed in two ways: pushing the OPN/CLS button or pushing the PLAY button. Remote Only These eleven numeric buttons (labelled 1 through 0 and >10) are used to directly access a track from the IR remote control instead of stepping through the tracks using the TRACK buttons. The first ten tracks on a disc can be selected by pressing the corresponding button. For example, to play the third track, press the 3 button on the remote control. When accessing track numbers greater than 10, press the >10 button followed by the track number. For example, to select track 12, press the >10 button followed by the 1 button and then the 2 button. The number of the selected track will appear in the main numeric area at the center of the Display. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. If there are more than 16 tracks on the disc, all of the digits will light accompanied by the word OVER, regardless of which track is playing. [. . . ] Remote Only This feature automatically plays the first ten seconds of each track on the disc (or the memorized program). To stop scanning and resume normal operation at the current track, press the SCAN button again or press the PLAY button. The TIME button allows you to step through two alternative time displays. Pressing the button once displays the time remaining in the current track, which counts down as the track continues playing. [. . . ]