User manual ROTEL RCD-945AX

[. . . ] Heed all warnings and safety information in these instructions and on the product itself. You must allow a minimum 10 cm or 4 inches of unobstructed clearance around the unit. WARNING: The rear panel power cord connector is the mains power disconnect device. The apparatus must be located in an open area that allows access to the cord connector. [. . . ] Avoid placing the unit where it may be subject to excessive heat such as on top of a large power amplifier or near a heat register. For best performance, avoid placing the unit where it may be subject to vibration, such as near a speaker. The ring around the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. When the Power switch is in the On position, the remote control ON and OFF buttons may be used to activate the CD player or put it in Standby mode. In Standby mode the ring around the power switch remains lit, but the display is turned off. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. The cover of this manual has a fold out panel that shows illustrations of the front and rear panels and the RR-D97 remote control. Throughout this manual the items referred to in the text are identified by the corresponding call out. The items on the front and rear panels are identified with a number call out, such a 1. A lighted Display on the front panel of the RCD-945AX provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. A disc slot located in the center of the RCD-945AX, accepts the disc and pulls it into the disc transport. After the disc is loaded the display shows the number of tracks on the disc. 5mm mini-jack receives command codes from industry-standard infrared receivers via hard-wired connections. This feature could prove useful when the unit is installed in a cabinet and the front-panel sensor is blocked. Consult your authorized Rotel dealer for information on these external repeaters and the proper wiring of a jack to fit the minijack receptacle. Except where noted, all functions are available on the RCD-945AX front panel and the IR remote control. For example, to select track 14, press the >10 button followed by the 4 button. To select track 23, press the >10 button twice followed by the 3 button. pressing the { TRACK button returns to the beginning of the current track. [. . . ] If the REVIEW button is not press again, after 5 seconds the review process is terminated and the unit resumes whatever mode it was in before you started the review process or resumes Program Play with the current track. You may remove a selection from the Program Play list during the review procedure using the CLEAR button, as described below. This feature automatically plays the first ten seconds of each track on the disc (or the memorized program). To stop scanning and resume normal operation at the current track, press the SCAN button again or press the PLAY / qE button. [. . . ]