User manual ROTEL RCD-951

[. . . ] Do not route the power cord where it will be crushed, pinched, bent at severe angles, exposed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit. The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time. Immediately stop using the RCD-951 and have it inspected and/or serviced by a qualified service agency if: · Objects have fallen into or liquid has been spilled into the unit. [. . . ] Connect the left channel output of the RCD-951 to the left channel source input on the preamplifier or other component. Note: Should you move your CD player to another country, it may be possible to reconfigure it for use on a different line voltage. Opening the enclosure of the RCD-951 exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. The RCD-951 should be plugged directly into a 2-pin polarized wall outlet or into the switched outlet on another component in your audio system. Be sure the power switch on the front panel of the RCD-951 is turned off (in the "out" position). Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a month-long vacation, it is a sensible precaution to unplug your CD player (as well as other audio and video components) while you are away. [See Figure 3 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-951, taken before the built-in D/A converter. Before using the IR remote control, it is necessary to install two "AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR sensor located in the Display area on the front panel of the RCD-951. The number of the track being played and the elapsed time will be shown in the display, along with the PLAY indicator. However, you can select a different track using the TRACK buttons or the DIRECT ACCESS buttons (see below) before pressing the PLAY button to start playing a different selection. A lighted Display on the front panel of the RCD-951 provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. Pressing the STOP button twice quickly in succession cancels any programmed selections (see below). The disc continues to spin and play will be resumed from the current position. To resume playing the disc, press the PAUSE button again or press the PLAY button. A motor-driven disc drawer, located in the center of the RCD-951, slides out to accept a compact disc and retracts to play the disc. The drawer can be closed in two ways: pushing the OPN/CLS button or pushing the PLAY button. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. [. . . ] Press the button once and the RCD-951 will repeat just the current track, displaying the indicators REPEAT 1 in the Display. Press the button a second time and the RCD-951 will repeat the entire disc, displaying REPEAT ALL in the Display. As noted above, REPEAT can be used in conjunction with the RANDOM play feature. This feature automatically plays the first ten seconds of each track on the disc (or the memorized program). [. . . ]