User manual ROTEL RCD-991

[. . . ] WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. [. . . ] this signal is supplied by the RCD-991's back-panel digital output jacks. If you are not using the digital outputs, we recommend turning the switch off, because it removes the digital output circuitry from the signal path. The LED indicator above the switch and the DISPLAY will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. The RCD-991 can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Some of the buttons are duplicated on the front panel and on the IR remote control. However, there are many instances where the buttons are only available on one or the other. When the transport disc drawer is closed, pressing this button automatically opens the drawer. When it is closed with no disc, the display will read "NO DISC". When the drawer closes with a disc inserted, the DISPLAY will indicate the number of tracks on the disc and the total time of the disc in minutes and seconds. Before using the IR remote control, it is necessary to install two "AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR sensor located on the front panel of the RCD-991. The number of the track being played and the time remaining will be shown in the display, along with the PLAY indicator. However, you can select a different track using the TRACK buttons or the DIRECT ACCESS buttons (see below) before pressing the PLAY button to start playing a different track. A lighted DISPLAY on the front panel of the RCD-991 provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. The disc continues to spin and play will be resumed from the current position. To resume playing the disc, press the PAUSE button again or press the PLAY button. A motor-driven disc drawer, located in the center of the RCD-991, slides out to accept a compact disc and retracts to play the disc. [. . . ] This button allows you to remove a track selection from the memorized program play list during the review procedure described above. Follow the review procedure until the desired track number is flashing. Then, instead of pressing the REVIEW button to continue, remove the displayed track by pressing the CLEAR button while the number is still flashing. Dither is a very small amount of digital noise added to a signal to improve a CD player's overall sound quality. [. . . ]