User manual ROTEL RMB-1095

[. . . ] Connect the component to the power outlet only with the supplied power supply cable or an exact equivalent. Do not route the power cord where it will be crushed, pinched, bent at severe angles, exposed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit. The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time. [. . . ] The LED indicator above the switch will light, indicating that the amplifier is turned on. To turn the amplifier off, push the button again and return it to the out position. The heat sinks and ventilation openings in the amplifier are designed to dissipate this heat. There should be 10 cm (4 inches) of clearance around the chassis, and reasonable airflow through the installation location, to prevent the amplifier from overheating. Likewise, remember the weight of the amplifier when you select an installation location. Make sure that the shelf or cabinet can support its considerable bulk. Because of its high power rating, the RMB-1095 can draw considerable current and may tax your home's electrical circuit. Therefore, it should be plugged directly into a 3pin polarized wall outlet. A heavy duty multi-tap power outlet strip may be used, but only if it (and the wall outlet) is rated to handle the current demanded by the RMB-1095. With the switch in the +12V TRIGGER ON position, the amplifier is turned on automatically when a 12V trigger signal is present at the 3. The amplifier will go into standby mode if the +12V signal is not present. Turning the switch OFF cuts power to the amplifier, regardless of whether or not a trigger signal is present. Be sure the POWER SWITCH on the front panel of the RMB-1095 is turned off (in the out position). Then, connect the supplied power cord to the POWER CONNECTOR on the back panel of the amplifier and to the AC power outlet. Your RMB-1095 is configured at the factory for the proper AC line voltage in the country where you purchased it (either 115 volts AC or 230 volts AC with a line frequency of either 50 Hz or 60 Hz). THX grew from George Lucas' personal desire to make your experience of the film soundtrack, in both movie theaters and in your home theater, as faithful as possible to what the director intended. Movie sound tracks are mixed in special movie theaters called dubbing stages and are designed to be played back in movie theaters with similar equipment and conditions. The soundtrack created for movie theaters is then transferred directly onto Laserdisc, VHS tape, DVD, etc. , and is not changed for playback in a small home theater environment. THX engineers developed patented technologies to accurately translate the sound from the movie theater environment into the home, correcting the tonal and spatial errors that occur. This input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. NOTE: Should you move your RMB-1095 to another country, it is possible to configure your amplifier for use on a different line voltage. [. . . ] Place the connector lug around the shaft, or insert the bundled wire into the hole in the shaft. Most difficulties in audio systems are the result of poor or wrong connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RMB-1095, refer to the suggestions for the following conditions: The front panel PROTECTION INDICATORS light when the RMB-1095 protection circuits have shut off the amplifier. [. . . ]