User manual ROTEL RX-950AX

[. . . ] The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Operation Manual Protection panel Applicable models (as of July 2008) LCD MONITOR LB-1085 RX-950AX Unit: mm (inch) (The figure shows the approximate values. ) Thank you for purchasing a ROTEL product. [. . . ] There may be some deviations from these values in individual units. Operation Manual Protection panel Applicable models (as of July 2008) LCD MONITOR LB-1085 RX-950AX Unit: mm (inch) (The figure shows the approximate values. ) Thank you for purchasing a ROTEL product. Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section "To ensure safe and correct use". After reading the manual, keep it in a convenient location where it can be accessed at any time. · 1592 (62 11/16) TIPS - Please understand that Sharp Corporation bears no responsibility for errors made during use by the customer or a third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law. - This product and its accessories may be upgraded without advance notice. 2618 (103 1/16) 73 (2 7/8) To ensure safe and correct use This operation manual and the product use various displays and labels to ensure safe use. Ignoring these displays and labels and incorrectly using the product could have results as classified below. · The ambient temperature for the LCD Monitor is 0 to 35°C (32 to 95°F) when using the protection panel. 2) Attach the eye bolt connection plate (upper) and secure in place with the eye bolt used in step 1). Eye bolt connection plate (upper) 7 Secure the protection panel. 1) Secure the protection panel with the supplied M5 screws (4 M5 screws (long) on top, 2 M5 screws (short) on each side). M5 screw (long) Installation procedure Caution · The protection panel is large and heavy. · Mount the LCD Monitor in the dedicated stand or mounting brackets before mounting the protection panel. M5 screw (short) 4 Insert the hooks of the hoisting device into the eye bolts of the protection panel and slightly lift the panel. 2) Remove the 2 M16 bolt caps on the bottom. 1 Remove the 6 screws in the LCD Monitor (4 on top, 1 on each side). 2 Attach one spacer to each side of the LCD Monitor. [. . . ] M5 screw (long) Installation procedure Caution · The protection panel is large and heavy. · Mount the LCD Monitor in the dedicated stand or mounting brackets before mounting the protection panel. M5 screw (short) 4 Insert the hooks of the hoisting device into the eye bolts of the protection panel and slightly lift the panel. 2) Remove the 2 M16 bolt caps on the bottom. 1 Remove the 6 screws in the LCD Monitor (4 on top, 1 on each side). 2 Attach one spacer to each side of the LCD Monitor. [. . . ]