User manual ROWENTA RO8370EA SILENCE FORCE

[. . . ] Do not use The cord proper instructions relative to the safe use of the winder and cord for your vacuum cleaner must be replaced by an appliance and if they have fully understood the Approved Service Centre as special tools are required for repairs to avoid any risks. The mains plug should be protected with a 16 A Children must not play with the appliance. important:the circuit breaker is triggered while the appliance fuse at least. If is in Cleaning and maintenance of this appliance must operation, this may be due to the fact that other appliances with the not be carried out by children unless they are at high connected power are connected at the same time to the same electrical circuit. [. . . ] ) the safety device may be tripped and the appliance may make an unusual noise that is not serious. Do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter). Never place the foam and microfilter in the appliance unless they are completely dry. If you have any difficulties in finding accessories or filters for this vacuum cleaner, contact the Rowenta Customer Service. USE 1 • Fitting the elements onto the appliance Clip the end of the hose to the suction inlet located at the front of the appliance (fig. Fix the accessory support to the notch in the parking position located at the back of the vaccuum cleaner (fig. Note: The accessory support does not need to be removed to open the vacuum cleaner lid. €¢ Fit the metal telescopic tube to the end of the nozzle until you hear a click indicating that it is locked (fig. €¢ Fit the multi-surface nozzle (23) to the end of the metal telescopic tube until you hear a click indicating that it is locked (fig. €¢ Adjust the metal telescopic tube to the desired length using the telescopic system (TELESCOPIC SYSTEM) (fig. Fit the corresponding accessory to the end of the metal telescopic tube or the nozzle: - For rugs and carpets: use the multi-surface nozzle in the retracted brush nozzle position or the Turbo-brush* (fibres and animal hairs). Check and clean your vacuum cleaner and the different filters regularly. IMPORTANT: do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter). 2 • Cleaning the black foam filter (18a) IMPORTANT: clean the black foam filter every 6 months or when the suction is no longer satisfactory. ATTENTION: let the black foam filter dry completely and make sure it is completely dry before placing it back in the appliance. 3 • Cleaning the microfilter (18b) IMPORTANT: clean the microfilter every 6 months. Remove the filtration cassette (18) then separate the black foam filter (18a) from the microfilter (18b) (fig. ATTENTION: let the microfilter dry completely and make sure that it is well dry before refitting on the appliance. 1 • Emptying the dust compartment (5) After each use, empty the dust compartment as follows: Take the dust compartment by the handle and remove it (fig. Separate the fine dust compartment (5b) from the main compartment (5a) (Fig. IMPORTANT: do not use the vacuum cleaner once the maximum level (6) is reached on the dust compartment. * According to model: these systems are specific to certain models or are accessories available as an option. [. . . ] 6 • Cleaning your vacuum cleaner Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry with a dry cloth. Wash the dust compartment (5a+ 5b) under clear or soapy water, then dry with a dry cloth. The transparency of the dust compartment and/or front cover and/or cover may change over time; this does not affect the appliance performance. Cleaning the air/dust separator system (4) Remove the hose from the vacuum cleaner. [. . . ]