Detailed instructions for use are in the User's Guide.
[. . . ] 17 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or someone similarly qualified, in order to avoid hazard.
household use only before using for the first time
1 Fill the reservoir, and run the appliance without coffee. 2 Let it cool, discard the water, then use it normally.
bottled water
3 If you use bottled water, check that there are no added ingredients, flavourings, etc. , and use "flat" water, not "sparkling". The carbon dioxide which gives the "sparkle" will adversely affect the flavour of your coffee.
preparation
4 Sit the appliance on a stable, level, heat-resistant surface. [. . . ] 39 Let the filter and filter holder cool, then prise the filter out of the filter holder. 41 Replace the filter in the filter holder and press it down to lock it in place. 45 Unplug the appliance, let it cool down, then clean it ( see "care and maintenance").
finished?
cappuccino
46 Cappuccino is espresso with a frothy milk top. 47 You'll need a mug or small jug containing cold milk, and a cup to collect drips. 48 To allow room for the froth, don't fill the mug more than two thirds full. 49 Ideally, the mug should be tall and narrow, as the milk must be deep enough to cover the end of the frother without it hitting the bottom of the mug. 50 We've found that semi-skimmed milk gives better results than whole milk. You'll need to experiment to find which type works best for you in your area. Too much steam will flatten the milk, leaving you with nothing but hot, watery milk.
frothing
52 For best results, do the frothing straight after you have made your coffee, while the appliance is still hot. 54 Bring the mug containing the milk up to the frother and hold it so that the end of the frother is just under the surface of the milk. 58 Move the jug up and down slightly, keeping the end of the frother just below the surface of the milk. 59 Don't lift the end of the frother out of the milk, or it'll spatter. 64 To make cappuccino, spoon the froth on top of the cup(s) of espresso.
5
clean the frother
65 You must clean the frother, steam pipe, and nozzle immediately after use, to prevent milk deposits going hard, and blocking the steam pipe and nozzle. 66 Hold a cup under the frother, so that the end of the frother is well inside the cup. 70 Let a little steam through, to remove any milk from inside the frother. 72 Press and release the S button again, to stop steam production.
warming milk
73 To warm milk for your coffee, follow the procedure for making froth, but immerse the frother in the milk, so the steam bubbles through the milk, warming it up. [. . . ] To replace the plug, fit the green/yellow wire to E or E, the blue wire to N, and the brown wire to L. Don't use a non-rewireable/moulded plug unless the fuse cover is in place. If you remove the plug, dispose of it.
spare parts
Note the Model No (on the rating label) and the parts you need, ring 0845 658 9700 or email service@saltoneurope. com for prices, then purchase using VISA or MASTERCARD.
service
The product isn't user-serviceable. [. . . ]