Detailed instructions for use are in the User's Guide.
[. . . ] 11 Check the lid is properly closed before switching the kettle on, otherwise it may not switch off. 12 Check the kettle is properly located on the stand before switching on. 13 Don't switch on unless the kettle contains at least 2 cups of water. 14 Don't fill past max, or water will be left in the water tank which can't be filtered. [. . . ] 4
11 Squeeze the lid release, then lift it up and back, to open the lid. 12 Turn the water tank so the two cut-outs are located equally on each side of the spout. 14 Quickly fill the water tank up to the rim, then allow the water to pass through the water filter. 16 If the kettle hasn't been used for over 2 weeks, we recommend you: · Empty the kettle · Open the lid, take the water tank out of the kettle, turn the water filter to your left to release it from the water tank, then follow steps 3 to 15, to prepare the water filter.
filling
1 Put the stand on a stable, level surface. Route the cable so it doesn't overhang, and can't be caught or tripped over. 5 Fill the water tank with at least 2 cups of cold water, but don't fill over the rim, or the water will bypass the filter. If you want more, gently add more water to the water tank, keeping your eye on the rising water level in the kettle. 7 Don't let the filtered water in the kettle exceed the -max- (1. 5 litre) mark. 8 Check the lid is closed, otherwise the kettle may not switch off when it boils.
switching on
1 Check that the kettle is off lift the switch up (0). 3 Gently position the kettle on the stand take care not to spill any water. nb You don't have to wait for the water to be filtered before switching the kettle on. Water passes through the water filter quickly, and all the water will be filtered before the kettle finishes boiling.
switching off
1 When the water has boiled, the kettle will switch off automatically, the switch will return to the "off" position (0), and the lights will go out. 2 To switch off manually, move the switch to 0, or lift the kettle off the stand.
5
the water filter
To ensure you get the best filtered water from your kettle, you have to change the water filter regularly. The water filter will filter 200 litres of water, which is approximately 8 weeks, for a typical family, in a hard water area. We recommend that the water filter is changed at least once every 10 weeks.
changing the water filter
1 Open the lid 2 Lift the water tank out of the kettle. 3 Hold the water tank and turn the water filter to your left, to release it from the water tank. 5 Prepare the new water filter for use, as described on page 4.
the reminder
Remembering when to change the water filter is perhaps the hardest part. We've built a reminder into the stand, so you know when next to change the water filter. For example, it you want to change the water filter every month (4 weeks) and it's now April (4), change the water filter, then set the reminder to 5 (May). By looking at the reminder, you can tell you need to change the water filter in May.
general
When you lift the kettle from the stand, you may see moisture on the surface of the base. This is the steam used to switch the kettle off automatically, which then condenses and is allowed to escape via vents in the underside of the kettle. You may notice discolouration of the coating on the floor of the kettle. [. . . ] Rinse the filter under a running tap while brushing with a soft brush. Rinse the kettle out with fresh water, in case scale particles have fallen inside.
connection
The product must be earthed. To replace the plug, fit the green/yellow wire to E or E, the blue wire to N, and the brown wire to L. Don't use a non-rewireable/moulded plug unless the fuse cover is in place. [. . . ]