User manual RUSSOUND A-OM
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RUSSOUND A-OM. We hope that this RUSSOUND A-OM user guide will be useful to you.
Manual abstract: user guide RUSSOUND A-OM
Detailed instructions for use are in the User's Guide.
[. . . ] During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. The unit must be returned to Russound at the owner's expense and with prior written permission. [. . . ] A-BUS is a registered trademark of LeisureTech Electronics Pty Ltd Australia.
grounding plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched, particularly at plugs, convenience receptacles, and the point where it exits from the apparatus.
11. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart-apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If you have any questions, call Russound at 1. 800. 638. 8055 or 603. 659. 5170.
Product Overview
The Russound A-OM A-BUS Output Module provides a fixed-level stereo line output from an A-BUS keypad port on any A-BUS hub or other A-BUS-ready multiroom system. This is useful for sending fixed-level audio signals to an external amplifier or receiver for amplification. The module can be located with the system controller or hub, or remotely with the amplifier or receiver. It connects to the A-BUS port with a single CAT-5 cable and provides RCA jacks for the audio output. The A-OM also provides connections for an infrared receiver so the source equipment can be operated from the zone by an IR remote control.
5 Forbes Road, Newmarket NH 03857 USA Tel 603. 659. 5170 · Fax 603. 659. 5388 www. russound. com
Copyright © 2006 Russound. 28-1244 04/27/06
Features
· · · · Provides fixed-level stereo line output Works with any standard A-BUS keypad port Includes IR receiver input terminals Compact chassis mounts on any surface
Installation
Normally the A-OM should be installed near the A-BUS hub or multiroom system controller. However, if the amplifier or receiver is located remotely from the hub or controller, it's better to locate the A-OM with the amplifier or receiver to simplify the line-level audio connections.
for power and ground, and the other twisted pair for status and IR signal. Make sure an A-PS Power Supply is plugged into the power jack on the A-BUS hub or multiroom system controller.
Considerations
Since the A-OM takes the place of an A-BUS keypad, some means of selecting sources for the zone must be provided when the A-OM is used with a multisource hub or controller. This can be done with either a system keypad or touchscreen connected to the same zone, or an IR receiver connected to the A-OM. [. . . ] (If using wall plates, punch down the CAT-5 per the T568A standard and use standard 4-pair straight-through RJ-45 patch cables between the wall plates and the devices. )
RJ-45 Using T568A Wiring Standard
CAT-5 Cable CAT-5 A-OM
Line IN Speakers
Home Theater Receiver
Advantage Series Speakers
1
2
3
4
1
2
3
4
5
6
RCA Patch Cable Speaker Cable 858 or 858P IR Receiver
A-H484 Hub
A-BUS system
PW
TV
A-PS
SETUP
A-LRC1 Remote Control
R
VCR
Advantage Series Speakers
4 3
3 6 9 2 5
SO CO UR NT CE RO L 2
4. Connect the RCA Line Output jacks on the A-OM to a stereo line input on the amplifier or receiver with a stereo RCA interconnect cable.
CBL
ENT
ER
1
8
1
0
CH
LAS T
4
SLE EP
7
MU TE
INP UT
EXIT
VO L
GUID E
SELEC T
MEN
U
ALL
OFF
INFO
OFF
SEL ECT
4
2-Pair Shielded Cable CAT-5 A-OM R275HC Amplifier
ALTx-2D Volume Control Speaker Cable
ON
VO
L
IR receiver connection
1. If using an IR receiver, connect the receiver to the screw terminals on the A-OM as described in the receiver's instruction manual. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RUSSOUND A-OM
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RUSSOUND A-OM will begin.