User manual SAECO MILK ISLAND MKI001

[. . . ] Milk Island is not equipped with a connector suitable for being connected to a conventional plug. Subject to engineering and manufacturing changes due to technological developments. [. . . ] do not use sharp objects or harsh chemical products (solvents) for cleaning. Do not dry the machine and/or its components using a microwave and/or conventional oven. Replace the emulsifying group on the jug; pay attention that the cover is correctly inserted in the tube located inside the jug. For thorough cleaning, fill the clean jug with water and dispense steam. The jug and the emulsifying group's components can be sterilised with a 5% sodium hypochlorite solution. Their sterilisation is compulsory if they are not used for a long period of time. Warning: to disconnect Milk Island, position the coffee machine on its side. Before carrying out this operation, remove the water tank, drip tray and dregs drawer and empty the coffee bean hopper. After having emptied the containers, delicately turn the machine onto one side. 5 At this point, re-position the coffee machine in its correct position and put back all its components. 6 Turn the coffee machine on and follow the start-up procedure as described in the machine's operating instructions. Then wash and sterilise all Milk Island components and place them in a safe place for future installation; if available, we recommend using the original packaging. Please contact the service centre for any faults not covered in the above table or when the suggested solutions do not solve the problem. Never place live parts in contact with water: danger of short circuit! [. . . ] In case of failure, faults or a suspected fault after a fall, immediately unplug Milk Island from the machine (see uninstalling). All liability for damages caused by works not carried out in a professional manner, is declined. [. . . ]