User manual SAECO ODEA GIRO PLUS FULL

[. . . ] 3 Keep your hands and the cord away from hot parts of the appliance during operation. A short power-supply cord (or detachable power-supply cord) is to be provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. Longer detachable power-supply cords or extension cords are available and may used if care is exercised in their use. The marker electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance 2. [. . . ] NOTE: if the Intenza water filter is not used, insert the small white filter that was previously removed (step 1) into the water tank. Permanently on: signals the need to empty the dregdrawer; this operation must be performed with the machine turned on (steps 1 and 2, page 26). Permanently on : signals the machine is out of coffee, the water tank is empty, the drip tray is full or the dregdrawer is full (in this case, also empty the coffee grounds drawer in order to prevent failures). On and flashing slowly: signals that the brew group is not inserted, the dregdrawer is not inserted the coffee bean hopper lid is not on, the service door is open or the steam/hot water knob is not correctly turned to the desired position. On and quickly flashing: signals the need to prime the water circuit. Turn it on again after 30 seconds, wait until the machine stops and then turn it off again. If this signal appears again when the machine is turned back on, contact the customer service centre. To adjust the drip tray, lift it or lower it manually until it reaches the desired height. After 60 minutes of inactivity, the machine goes into stand-by mode, the boiler is no longer heated and all the lights turn off with the exception of the temperature light which will blink slowly. Coffee is a natural product and its characteristics may change according to its origin, blend and roast. The Saeco coffee machine is equipped with a self-adjusting system that allows the use of all types of coffee beans available on the market (not including flavored or carmelized). When this operation is completed, turn the knob until it is in the rest position ( ). Re-install the Intenza water filter (if previously removed); again; otherwise, make sure that the water tank contains the small white filter described on page 11. During normal operation, the message for emptying the coffee grounds may appear on the display (see page 12). The indicator light to empty the dregdrawer illuminates approximately every 15 coffee cycles. If the dregdrawer is emptied with the machine turned off, or when the indicator light is not illuminated (see page 12), the count of the coffee cycles is not reset. For this reason, the indicator light to empty the dregdrawer may illuminate even when it is not full. Do not immerse the machine in water or place any of its parts in a dishwasher. Do not use alcohol, solvents, benzene and/or abrasive objects to clean the machine. Do not dry the machine and/or its components using a microwave and/or conventional oven. Before filling the coffee bean hopper, clean it using a soft wet cloth. Before removing the brew group, remove the dregdrawer as shown in fig. [. . . ] Fill the water tank only with fresh drinking water: Hot water and/or any other liquid may damage the machine. Do not put fingers or any material other than coffee beans in the coffee grinder. Before manipulating the coffee grinder, turn off the machine's main switch and unplug the cable. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]