User manual SAECO ODEA GIRO

[. . . ] To disconnect, turn any control to "off", then remove plug from wall outlet. Any servicing, other than cleaning and user maintenance, should be performed by an authorized service center. To reduce the risk of fire or electric shock, do not disassemble the machine. 1 Check voltage to be sure that the voltage indicated on the nameplate corresponds with your voltage. [. . . ] Attention should be given to special blends, which require grinder adjustments in order to optimize the extraction of the coffee (see page 15). The adjustment must be performed using the small pin located inside the coffee bean hopper. This must be pressed down and turned using the supplied grinder adjustment key only. To adjust the drip tray, lift it or lower it manually until it reaches the desired height. Espresso coffee Café expresso Medium coffee Café moyen After 60 minutes of inactivity, the machine goes into stand-by mode, the boiler is no longer heated and all the lights turn off with the exception of the temperature light which will blink slowly. The coffee brewing cycle can be interrupted at any moment by pushing the button. To brew 2 cups, the machine dispenses the first coffee and briefly interrupts dispensing in order to grind the second serving of coffee. Press the coffee button: once for 1 coffee twice for 2 coffees Appuyer sur le bouton central. Dispensing may be preceded by short sprays of hot water, and scalding is possible. The hot water/steam wand may reach high temperatures: do not touch it with bare hands. Wait for the container to be filled with the desired quantity of hot water. Dispensing may be preceded by short sprays of hot water, and scalding is possible. The hot water/steam spout may reach high temperatures: do not touch it with bare hands. 7 After frothing the milk, brew coffee into the cup for a creamy cappuccino. When performing a descaling cycle, it is necessary to be present during the entire process (about 40 minutes). Descaling should be performed every 3 months, or when indicated by the machine. The used solution should be disposed of according to the manufacturer instructions and/or regulations in the country of use. Note: before starting a descaling cycle make sure that: 1 a container of adequate size is available; 2 the water filter (if inserted) has been removed. When the descaling light is flashing, a descaling cycle must be performed. Repeat steps 3 - 8 until all the descaling solution in the tank has been dispensed. When this operation is completed, turn the knob until it is in the rest position ( ). If not present, check that the small white filter described on page 11 is installed in the water tank. [. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the retailer where you purchased the product. To correctly use the Intenza water filter, please consider the following instructions: 1. Store the water filter in a cool area in which the room temperature is between +1°C to +50°C (34°F to 122°F). Carefully read the operating instructions and the safety warnings provided with each filter. [. . . ]