User manual SAECO XSMALL STEAM

[. . . ] Thank you for purchasing this highest quality espresso coffee machine and for your confidence in our company. Before operating the machine, we recommend carefully reading the operating instructions that explain how to use, clean and maintain it in perfect working order. Please refer to an authorized dealer, or to Saeco, if you have any questions. When using electrical appliances, basic safety precautions should always be followed, including the following: 1. [. . . ] 5A) - Insert the plug into the socket located on the back of the machine. 5B) - Insert the plug of the other end of the power cord into a wall socket with suitable power voltage. Make sure control dial (17) is on " " position; if this is not the case, set it to that position. 6) - Simply press the ON/OFF button (16) to turn the machine on; the warning light (18) will begin to blink rapidly indicating that the water circuit must be primed. the rinse/self-cleaning cycle is carried out: · When the machine is turned on (with cold boiler) · After priming the water circuit (with cold boiler) · During the warm-up phase (if a coffee product has been brewed) · When the machine is turned off (if a coffee product has been brewed) Note: Place a container beneath the dispensing spout (5) before the dispensing starts (Fig. A small amount of water will be dispensed which will rinse and heat all the machine components; in this phase the lights will flash counter-clockwise. When water regularly comes out and the warning light (18) will blink slowly, indicating that you can turn off the control dial, rotate the control dial counter-clockwise to set it back to the " " position. At this point the temperature light (19) begins to blink slowly, indicating that the machine is in warm-up mode. Note: Before starting the machine after long periods of inactivity or if the water tank has been completely emptied, it is recommended that the circuit be primed. When warm-up is complete, the machine performs a rinse cycle of the internal circuits (see section 4. To brew coffee, dispense hot water or steam, and for a proper use of the machine, carefully follow the The machine that you have bought allows for certain adjustments that will permit you to use it to its full potential. Coffee is a natural product and its characteristics may change according to its origin, blend and roast. The Saeco coffee machine is equipped with a self-adjusting system that allows the use of all types of coffee beans available on the market (not including flavored or carmelized). The machine automatically adjusts itself in order to optimize the extraction of the coffee, ensuring perfect compression of the beans to obtain a creamy espresso coffee that will release all the aromas, regardless of the type of coffee used. The optimization process is a learning process that requires the brewing of a certain number of coffees to allow the machine to adjust the compactness of the ground coffee. Each time you press and release a coffee button, the machine brews a pre-programmed amount of coffee. Each button may be individually programmed for a specific brew setting. As an example, the following procedure describes the programming of the small coffee button (14), which is normally associated with espresso coffee. 12) - Press and hold down the small coffee button; the large coffee button blinks during this phase. Note: Should the machine not brew coffee, make sure that the water tank (9) contains Before brewing coffee, make sure that the green temperature light (19) is steady on and that the water tank and the coffee hopper are full. Keep the control dial (17) in the " " position, during the coffee brewing cycle. 12) - To brew coffee, press and release: the small coffee button for an espresso coffee; the large coffee button for a long coffee. [. . . ] Saeco descaling solution should be disposed of according to the manufacturer instructions and/or the regulations in the country of use. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. - Deliver the appliance and power cord to a service center or public waste disposal facility This product complies with eu directive 2002/96/ec. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ]