User manual SAGEM AXIUM DLP-50

[. . . ] This product was manufactured with the greatest care and we hope that it will provide you joy and spectacular sensations for many years. This product is extremely complete and we recommend that you first refer to Chapter 2 " SET UP" and Chapter 3 "First Rapid Installation" before reading the whole user manual. We recommend you to keep this document in a safe place in order to be able to refer to it afterwards. If you happen to have any potential problem for which Chapter 10 does not provide solution, please contact your retailer or distributor. [. . . ] "PIP/PAP" will restore the sound of the inset picture in PIP mode or the left-hand picture in PAP mode to the headphones. ⷠChoice of PIP and PAP preference PIP yes and PAP yes Pressing the F button more than once will take you to PIP, PAP and then the full screen in succession. PIP yes and PAP no Pressing the F button more than once will take you to PIP and then the full screen in succession. PIP no and PAP yes Pressing the F button more than once will take you to PAP and then the full screen in succession. PIP no and PAP no Pressing the F button more than once will have no effect. This preference allows you to choose alarm mode or to move to standby. "Manual": exit from standby and move to standby by pressing standby button * on the remote control or the front panel. "Auto": exit from standby or move to automatic standby commanded by exit from standby or move to standby of the equipment connected to the "SCART" connectors at the rear. Your Flat Screen DLPTM offers you a large selection of connectors to attach the equipment of your choice. You are advised to carry out the connections when the appliances are switched off. For ease of listening, mute the sound on your Flat Screen DLPTM (see chapter 8. The DLPTM technology causes a slight delay in picture processing, so connect your amplifier to these sockets and not to those of the source. Press the MENU key then select "OPTIONS" using the B button and validate using OK. If your code is not 0000, this screen is protected and you must enter your code. This option allows you to select the sources used but only displays them when you select sources in daily use. For each connector, you can: · Validate connected equipment by pressing the red key several times until "YES" (or "NO" for an unused connector) is displayed. Select "C+" if you have connected your C+ decoder to SCART 2. You can adjust and save your own parameters using: BALANCE Adjusting the balance affects the levels of sound between the right and left speakers. This allows you to obtain a sound level that is suited to your listening position. WOOFER VOLUME This affects the sound volume in your woofer to allow you to balance the right and left channels. HIFI OUTPUT VOLUME This allows you to set an output level (fixed or adjustable by your flat screen DLPTM remote control. Mode (internal speakers): the choice depends on the programme you are watching (stereo, mono). [. . . ] Symptoms: After initial set-up and after connecting your Flat Screen DLPTM, the on/off indicator light does not light up. The appliance does not switch on when the on/standby button on the front panel or the on/standby button on the remote control is pressed. The on/off switch is green and the Flat Screen DLPTM menus are available: Check that your video appliances are connected correctly and that you have selected the correct source for your Flat Screen DLPTM (Chapter 8. Check that the aerial lead is correctly connected to the wall socket of your Flat Screen DLPTM. [. . . ]