User manual SAGEM D10T

[. . . ] Your telephone must be operated at temperatures ranging from 5°C and 45°C. Only use the supplied power adapter, connect it to the base socket according to the installation instructions provided in this booklet and the indications on the identification (1) label affixed to it (voltage, current, electric network frequency) . This telephone was designed for use on the public switched telephone network (PSTN). To avoid damaging your handset, only use certified rechargeable batteries, never use non rechargeable batteries, respect polarity when inserting the batteries in the handset battery compartment. [. . . ] Transferring a Phone Number from the Redialling Memory or Caller ID List 1. Select the redialling memory (press once, the symbol is displayed) or Caller ID list (press twice, the symbol blinks). Press to confirm. OK Incoming Call Storage The last 20 incoming calls are stored in the Caller ID list with the phone number and the date and time the phone number was transmitted (the date and time must have been set on the handset). If no phone number has been transmitted, four dashes are displayed in place of the phone number. The calls are registered regardless of whether or not they have been answered. New, unanswered calls symbol blinking are shown on the display by the in the standby state. Opening the Caller ID List · Press and hold delete all the number. Note: The call duration timer will not be displayed during an emergency call. OK 3. If you have subscribed to the Caller ID service, the ---- is replaced with the caller's phone number. Taking a Call If the handset is on the base station: · Take it off the base station. If the auto-pickup function is enabled you can now answer the call directly (refer to § 7. 1. 3 "Activating/Deactivating the Auto-Pickup Mode"). If the handset is not on the base station: · Press any key to answer the call. press the The handset is automatically switched back on when placed on the base station. C C 4. 3. The entire directory will be cleared if you press for more than 5 seconds. Call Timer The call timer display starts 10 seconds after you make a call. Creating an Emergency Number · Press + 1 + 3. · Use to select the ringer volume. Switching Key Beep On/Off · Press + 1 + 1 + 4. Keyguard The keyguard function blocks the handset keys to avoid pressing them unintentionally (e. g. , when carrying symbol is the handset in your pocket). To activate keyguard: press and hold down the key until the shown on the display. To deactivate keyguard: press and hold the key until the symbol disappears from the display. Keyguard is also deactivated when you replace the handset on the base station. 3. 2. 8. Microphone MUTE Function During a call you can switch off ("mute") the microphone. Deactivating the MUTE Function symbol to select the desired phone number. · Enter the emergency maximum). [. . . ] Dialling Restrictions (Call Barring) · First enter the current PIN (4 digits), then enter the new PIN (4 digits). Guarantee terms and conditions Should your telephone be defective, despite our care, please see your reseller with the proof of purchase that he gave you. For all claims made under the SAGEM SA international guarantee, make sure that the material was used in compliance with its operating instructions and its intended use, and that you have the cash register receipt or the purchase invoice specifying: the date of purchase, the name of the reseller, the reference and serial number of the product. However, no coverage shall be given under this guarantee if the following conditions are applicable: · · · · · The required documents have been modified or altered in order to take advantage of the guarantee. [. . . ]