User manual SAGEM MF 9535/ MF 9545

[. . . ] MF9500 Operation Manual for Copier 30000113480-01 S INTRODUCTION This manual describes only copier features. For operation procedures relating to both the basic printer and copier features, refer to the "Operation manual (for printer operation and general information)". General information required for loading paper, adding toner, misfeed removal, and operation of peripheral devices are described in that manual. Separate manuals are provided for the operation of network scanning and facsimile functions. [. . . ] The automatic exposure level can be adjusted using a key operator program. (page 33) 15 REDUCTION/ENLARGEMENT/ZOOM Reduction and enlargement ratios can be selected either automatically or manually as described in this section. Automatic selection will enlarge or reduce images based upon the original size and copy paper size to give the best possible fit of the image to the copy paper. There are three preset reduction ratios (25%, 64% and 77%) and three preset enlargement ratios (121%, 129% and 400%) available for the inch system. There are four preset reduction ratios (25%, 70%, 81%, 86%) and four preset enlargement ratios (115%, 122%, 141%, 400%) available for the AB system. Automatic selection (auto image) The reduction or enlargement ratio will be selected automatically based on the original size and the selected paper size. (page 7) feeder tray or on The detected original size will be displayed. Automatic selection can be used only for 11" x 17", 81/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2" size originals and copy paper in the inch system and A3, B4, A4, A4R or A5 in the AB system. other desired such as 4 Make all or the number ofsettingsand press exposure copies, the [START] key. When copying from the document glass in the sort mode, touch the [READEND] key after all originals have been scanned. (step 7 on page 13) 2 Touch the [PAPER SELECT] key and then select the desired paper size. 1. A3 When the desired paper size key is touched, the paper size will be highlighted and the paper size setting window will be closed. If paper of the desired size is not loaded in any tray, load paper of the required size in a paper tray and enter the paper size. To cancel the auto image mode, touch the [AUTO IMAGE] key again to clear the highlighted display. IMAGE] 3 Touch the [AUTO82 1 key. AUTO PAPER SELEC AUTO IMAGE COPY RATIO The [AUTO IMAGE] key will be highlighted and the best reduction or enlargement ratio for the original size and the selected paper size will be selected and displayed in the copy ratio display. NOTE If the message "ROTATE ORIGINAL FROM TO " is displayed, change the orientation of the original as indicated in the message. When the message above is displayed, copying can be done without changing the orientation, but the image will not fit the paper correctly. 16 REDUCTION/ENLARGEMENT/ZOOM Manual selection the original in the document 1 Place the document glass. (page 7) feeder tray or on NOTE When the document feeder is being used, the available copy ratio range is 25% to 200%. other desired such as 5 Make all or the number ofsettingsand press exposure copies the [START] key. When copying from the document glass in the sort mode, touch the [READEND] key after all originals have been scanned. (step 7 on page 13) 2 Touch the [COPY RATIO] key. 100% COPY RATIO The preset copy ratio keys for reduction and enlargement, the keys for [ZOOM] and the [100%] key will be displayed. the copy ratio by touching a 3 Selectratio desiredreduction or enlargementfixed copy key for and touch the [OK] key. keys to 100 25% ZOOM % OK 400% 10 B4 A3 B5 B4 B5 70% B5 A5 81% A4 A3 B4 A4 A4 A4 115% A5 B5 122% B5 A3 A4 A4 B4 B5 86% B4 B4 141% A3 AUT IMAG If the message "IMAGE IS LARGER THAN THE COPY PAPER. " appears, image loss will occur. In this case either continue with image loss or change the copy paper size or copy ratio. size 4 Ensure that the desired paperon thehas been automatically selected based selected copy ratio or select another size as needed. PAPER SELECT 86% COPY RATIO If another size paper is selected, the auto paper select display will be cleared. 17 SPECIAL PAPERS If a bypass tray and a duplex module, a duplex module/bypass tray or a multi purpose drawer*1 is installed, special papers can be fed. These include transparency film, postcards, labels, envelopes*2, and plain paper. *1 The upper tray of a stand/3 x 500 sheet paper drawer or a stand/MPD & 2000 sheet paper drawer is equivalent to the multi purpose drawer. *2 Envelopes can be set in the multi purpose drawer and in the upper tray of a stand/paper drawer. (page 7) feeder tray or on special 2 Load the purposepaper in the bypass tray or in the multi drawer. For the paper loading instructions see "Loading paper in the bypass tray" (page 5-3) of the "Operation manual (for printer operation and general information)" or "Loading paper in the multi purpose drawer" (page 121) of the "Operation manual (for printer operation and general information)". 3 Touch the [PAPER SELECT] key and then select the bypass tray or the multi purpose drawer. 1. A4 COLOR 2. paper type can be set by touching the [PAPER TYPE] bypass tray, the desired 3. 4. other desired such as 4 Make all or the number ofsettingsand press exposure copies, the [START] key. When copying from the document glass in the sort mode, touch the [READEND] key after all originals have been scanned. (step 7 on page 13) 18 SPECIAL MODE When the [SPECIAL MODES] key on the basic screen of the copy mode is touched, the special modes screen containing six special function touch keys will appear. [. . . ] 5-1/2" x 8-1/2" or A5 Image loss: Max 21/64" or 8 mm (leading edge and trailing edge in total), max. type: 4. 6 seconds * Paper is fed from paper tray 1, quick scan from document glass (page 33) is set, the original scanning resolution on the document glass is set to 600 x 300 dpi and no optional hard disk drive is installed. Variable: 25 to 400% in 1% increments, total 376 steps Fixed presets: 25%, 64%, 77%, 100%, 121%, 129%, and 400% for inch system, 25%, 70%, 81%, 86%, 100%, 115%, 122%, 141%, and 400% for AB system 999 copies; subtractive counter Warm-up time First-copy time* Copy ratio Continuous copy Copying speed 35 copy/min. type 11" x 17" or A3 8-1/2" x 14" or B4 8-1/2" x 11" or A4 8-1/2" x 11"R or A4R 17 copies/min. [. . . ]