User manual SAMSUNG UA19F4000AM

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SAMSUNG UA19F4000AM. We hope that this SAMSUNG UA19F4000AM user guide will be useful to you.


SAMSUNG UA19F4000AM : Download the complete user guide (4599 Ko)

Manual abstract: user guide SAMSUNG UA19F4000AM

Detailed instructions for use are in the User's Guide.

[. . . ] Indd 1 2013-04-01 5:05:13 safety instructions Throughout this manual, you’ll see Warning and Caution notes. These warnings, cautions, and the important safety instructions that follow do not cover all possible conditions and situations that may occur. It’s your responsibility to use common sense, caution, and care when installing, maintaining, and operating the dishwasher. IMPORTANT SAFETY INSTRUCTIONS What the icons and signs in this installation guide mean: WARNING Hazards or unsafe practices that may result in severe personal injury or death. [. . . ] This temperature range provides the best washing result and shortest cycle time. temperature should not exceed 149 ˚F (65 ˚C) to prevent damage to dishes. Ensure that the water supply valve is turned off before connecting the hot water supply line to the dishwasher. Seal the hot water supply line connections using teflon tape or sealing compound to stop any water leakage. The hot water supply line must pass through the channel on the bottom of the dishwasher as shown in Figure 2. The drain hose connected to the dishwasher must be run through the hole in the side wall so it can be connected to the drain outlet of the sink. When you install the dishwasher, ensure there is nothing on the drain hose and be careful not to tear it during the installation process. Indd Sec3:9 2013-04-01 5:05:22 installing the dishwasher STEP 4 CHECK THE ELECTRICAL REQUIREMENTS AND CAUTIONS The electrical requirements for the dishwasher are as follows: • In the United States, install in accordance with the National Electric Code/State and Municipal codes and/or local codes. - Use flexible, armored or non-metallic sheathed, copper wire with a grounding wire that meets the wiring requirements for your local codes and ordinances. - Use the strain relief method provided with the wiring junction box or install a U. € For power cord connections - The power supply cord must plug into a mating three prong, grounded outlet, located in the cabinet next to the dishwasher opening. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of the cabinet opening from under the countertop to the floor. Place the dishwasher so that the hot water supply line is in the left channel and the power cable is in the right channel of the base of the dishwasher. Use standard duct tape or cable ties to secure the water line and electrical cable to their adjacent channels in the base. This can prevent the the water line and electrical cable from being squeezed when you push the the dishwasher into place. Make sure the hot water supply line is not twisted, and then connect the hot water supply line to the elbow joint. If possible, gently pull any excess lengths of water supply line, drain hose, or power cable back as you move the dishwasher. CAUTION Do not place the dishwasher on the water supply line, drain hose, or power cable. <Figure 7> <Figure 6> Drain hose Power cable Hot Water Supply Line Hot Water Supply Line Elbow( ³/8” (9. Doing so may damage the water inlet valve and cause a water leak 14_ installing the dishwasher installation_DD68-00046A-06_EN_130401. indd Sec3:14 2013-04-01 5:05:23 STEP 8 LEVELING THE DISHWASHER 1. Open the door and place the level against the top of the tub on the inside and check if the the dishwasher is level. [. . . ] You must connect the drain hose in accordance with the water pipe installation regulations in your region. With disposal With disposal Disposal with an air gap Air gap Without an air gap Drain hose Hose clamp Hose clamp 18_ installing the dishwasher installation_DD68-00046A-06_EN_130401. If needed, cut the drain hose so its end fits onto the sink connector (½ in. If the end of the drain hose does not fit onto the drain hose connector of the sink, use an adaptor purchasable at a plumbing/hardware supply store. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SAMSUNG UA19F4000AM




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SAMSUNG UA19F4000AM will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.