User manual SANGEAN CCRADIO

[. . . ] 8) Ventilation: This radio should be situated so that its location or position does not interfere with its proper ventilation. For example, the radio should not be used on a bed, sofa, rug or other soft surfaces that may block the ventilation openings. It should not be placed in a built-in situation like a cabinet that may reduce air flow through the ventilation openings. 9) Heat: Never put the radio in direct sunlight in an unventilated area or behind glass like a car's interior. [. . . ] 4) You must press the Band/Time Set button again to complete the alarm setting. You can also set the alarm time immediately after selecting the radio or buzzer alarm as describe above if you are a whiz. Page 11 To 1) 2) 3) NOTES ON THE ALARM: To stop the alarm from going off every day press the Alarm button on top of the radio until both symbols disappear. Once the alarm is set, it will automatically go off the next day at the same time. If the radio alarm is selected, turn the radio to your favorite station before setting the alarm. When the alarm activates the radio will play the last station listened to. The tone alarm is called HWS or Humane Wake (if that is possible) System. The alarm tone beep will increase in volume every 15 seconds for one minute followed by one minute of silence before repeating the cycle. The alarm system will sound for one hour unless turned off by pressing the POWER button. SNOOZE FEATURE: When the alarm is sounding, if you press any button except the POWER button the alarm will temporarily stop for five minutes. The little Z's and alarm symbol will flash on the display while the radio is in snooze mode. To shut off the alarm and snooze feature press the POWER button. SLEEP TIMER FEATURE: Your CCRadio is equipped with a Sleep Timer that enables the radio to continue playing for up to 90 minutes after activation, then shuts the radio off. To utilize this feature, have the radio on and tuned to the station you want to listen to, then press the button that has the pictogram of a person in bed. *You can also activate the sleep timer and turn on the radio at the same time by pressing the sleep timer button. There are seven standard NOAA weather channels used in the US and Canada. This radio receives broadcasts up to 50 miles from transmitting stations. 1) To listen to the standard NOAA weather channels, turn the radio on, press the BAND button until WX shows up on the display. The telescopic whip antenna may need to be in the up position to receive a station clearly. Pressing the tuning up or down buttons will toggle you through the seven programmed channels. There should be one or more weather service stations broadcasting in your local area. You will hear a report that is updated usually once or more per day for your area. If there is a severe weather or weather related emergency NOAA will update the weather broadcast more frequently. After locating and tuning in your weather station the radio can now be placed into WXALERT mode. The WXALERT mode enables you to listen to your favorite AM or FM station or turn the radio off, and still receive an alert signal warning you of a special emergency. There are two active WXALERT modes on the CCRadio: SETTING THE WEATHER ALERT 1) To place the radio in WXALERT mode, press the ALERT button for two seconds: You will hear an audible beep and see the word ALERT appear on the display. [. . . ] · Try a battery operated radio to see if the interference is coming in from the AC 120v line, through the air, or both. Turn off one circuit at a time to isolate where the noise is coming from. Turn the radio until the loudest noise is heard and the front and back of the radio will point to the noise origin. · Carry a radio around the neighborhood and see if you can find the origin of the noise. [. . . ]