User manual SCOTSMAN SCV32

[. . . ] The SCV can be built into an under counter application without loss of capacity or efficiency due to the forced draft condenser under the unit. This manual outlines the installation, use and maintenance of the wine storage unit. [. . . ] Follow all local, state and national codes. Adjust Legs to Level the Cabinet June 2003 Page 5 SCV32 Switch It On Locate the temperature control knob at the bottom front of the unit. You should immediately hear a humming noise and feel air blowing in and out the vents near the knob. After 10 minutes open the door and feel the back panel inside the cabinet. To switch refrigeration off: Rotate the temperature control knob fully counter clockwise. The light will still be functional. Temperature Control Knob Cool Air In Warm Air Out June 2003 Page 6 SCV32 Load It The six racks are designed to hold five bottles each with the necks pointing at each other. If large bottles do not fit between the racks, remove a lower rack and place the bottles on the rack below. To remove a rack, take off the bottles on that rack and pull it out until it stops, then lift up the front of the rack and remove it from the unit. Reversing every other rack allows more light to penetrate the lower racks for an improved display of a full cabinet. Note: Rack removal will be difficult if the door cannot open to at least 115o, as in a corner application. Caution: Loaded racks contain heavy wine bottles and when several are pulled out the unit can tip forward unexpectedly. June 2003 Page 7 SCV32 Set the Temperature Rotate the temperature adjustment knob until the desired temperature is lined up with the indicator. Interior cabinet temperatures will be a bit warmer at the top or front and cooler at the bottom. Temperature Reference: There are several temperature zones inside the SCV cabinet. The temperature can also be controlled by rotating the temperature control knob. When fully loaded with room temperature product the SCV32 will operate continuously for as much as 24 hours to reduce the temperature inside the cabinet to the desired point. If the unit is lightly loaded or empty, it will turn on and off frequently. [. . . ] Unplug the unit. Electrical Shock Hazard Disconnect electrical power before beginning service 2. Unplug Unit Before Service Light Bulb Socket February 2003 Page 12 SCV32 Drain System The SCV has an internal drain system. [. . . ]