User manual SEVERIN BA 3286

[. . . ] Do not put it on or near hot surfaces or open flames such as hot-plates or gas rings. Great care is necessary when using any appliance, especially near children. Always remove the plug from the wall socket and place the iron back on its rest on the steam generator. When ironing is interrupted, the iron must be replaced on its rest on the steam generator. [. . . ] €“ As the iron is heating up, the temperature indicator lamp on the iron will be on. Button and the + / − buttons – Use the to set the appropriate hardness level as described in the section Adjusting the level of water hardness. Ironing – The symbol disappears once the water in the boiler has reached the required temperature. Now clean the appliance according to the instructions given in the paragraph General Care and Cleaning. This will remove possible dust particles from the sole plate and subsequently lessen the smell typically encountered when first switching on. General information about ironing Always check first whether a label with ironing instructions is attached to the article to be ironed. €“ The meaning of the ironing symbols is as follows: • synthetics (low temperature) •• silk and wool (medium temperature) ••• cotton and linen (high temperature) – These markings can also be found on the temperature control knob of the iron in the form of dot symbols. Laundry to be ironed should be sorted according to the fabric ironing temperature. When ironing highly sensitive fabrics, or if you are not sure about the fabric, carefully test-iron on a non-visible point, e. If the laundry is put into a dryer before ironing, the temperature should be adjusted to ‚iron dry‘. The appropriate level for steam ironing is indicated on the temperature control knob. €“ Place the iron on its rest and insert the plug into a suitable wall socket. Symbol starts flashing to indicate – The that the boiler is heating up. €“ Set the temperature control knob to the required ironing temperature according to the ironing symbols. €“ As the iron is heating up, the temperature indicator lamp on the iron will be on. €“ Use the + and – buttons to select the desired steam output: minimum , , medium . Ironing disappears out once – The symbol the water in the boiler has reached the required temperature. €“ As soon as the steam output indicator ‘4’ appears in the display, the water in the boiler is sufficiently hot for steam ironing. €“ You can now start ironing; press the steam button as required. €“ The steam function may also be used with the iron held vertically, to remove creases or wrinkles from fabrics. If, during ironing, the water reservoir becomes empty, simply re-fill it as described in the section ‘Filling with water’. Always replenish the water in starts good time, whenever the symbol flashing. [. . . ] €“ Replace the maintenance screw and ensure that it is properly fitted. Never open the boiler 14 during use; allow the appliance to cool down over night. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]