User manual SEVERIN KS 9822

[. . . ] ρ The cooling circuit in this appliance contains the refrigerant isobutane (R600a), a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Ensure, therefore, that none of the components of the refrigerant circuit become damaged during transportation and installation of the appliance. If damage to the cooling circuit does occur, do not switch on or connect the appliance to the mains power. In the case that there is an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from this area and that the room is then thoroughly ventilated. [. . . ] ρ The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or similar object. ρ In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. Before reversing the door, place the unit on its side, ensuring that it rests on a soft, smooth, nondamaging surface. Take off the door and place it also on a soft, non-damaging surface to protect it against scratching. Remove the hinge cover B from the inside of the door and install the hinge cover A provided into the hinge opening on the other side of the door. Remove both adjustable feet and the screws holding the lower hinge and the foot mounting. Unscrew the hinge pin and reposition it in the other opening in the hinge. Now fit the lower hinge and the foot mounting on the respective opposite sides. Take out the screws on the top left-hand side of the unit and replace them on the top right. Unscrew the hinge pin and reposition it in the other opening in the hinge. Unscrew the hinge pin and reposition it in the other opening in the hinge. Fit the hinge pin into the corresponding opening in the door and tighten the screws to the secure the upper hinge to the housing. Now change the position of the door handle: Take off the screw covers, remove the screws and then take off the handle. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. € After switching on, the temperature control should be set to its highest setting. 30 minutes, the temperature should be changed to a medium setting, which is usually sufficient for home or office use. 20 – Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. [. . . ] € The following table lists the possible malfunctions, their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. This guarantee does not affect your statutory rights, nor any legal rights you may have as a consumer under applicable national legislation governing the purchase of goods. [. . . ]