User manual SEVERIN KS 9826

[. . . ] The appliance must only be used by persons familiar with these instructions. Connection to the mains supply The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label. ρ To prevent noise vibration, ensure that the power cord does not touch any part of the rear of the unit General information  This appliance is a compressor refrigerator, designed for short-term storage of food. [. . . ] Remove the adjustable foot (4) from the left-hand side and re-fit it on the right. Ensure that the hinge pin is inserted into the guide bushing (hole) on the lower part of the door frame. Attach the upper hinge plate (5) (removed earlier in step 3) on the left-hand side. Ensure that the hinge pin is inserted into the guide bushing (hole) on the upper part of the door frame. Adjust the closed door to its proper position and tighten the screws of the upper and lower hinge plates. Replace the screws (10) und the screw covers (11) in the top panel (9). Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Take off the protective cover from the left-hand side and re-fit it in the opening on the righthand side. Turn the door round 180°, place the lower hinge onto the lower door pin and insert the upper door pin into the upper hinge. Now slide the lower hinge into the corresponding opening, ensuring it locks into place. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the 16 temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. € After switching on, the temperature control should be set to its maximum setting. € After 30 minutes, the setting should be changed to a medium setting, usually sufficient for home use. Following a power interruption, or if the unit has been switched off on purpose, it may take 3 to 5 minutes before it switches on again. In position ‘0’, the cooling function is switched off, though the appliance is still connected to the mains. Interior lighting Changing the light bulb: – Remove the plug from the wall socket. € Use a suitable screw-driver to remove the screw holding the light cover and take the cover off to the back. € Slide the cover back into position, replace the screw and tighten it. Freezer compartment door To ensure that frozen food will not de-frost prematurely, the door to the freezer compartment should be kept closed at all times. [. . . ] € The following table lists possible malfunctions and their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. If the problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. This can be checked by connecting another electrical device to the socket and checking for function. [. . . ]