User manual SEVERIN KS 9890

[. . . ] ρ The cooling circuit in this appliance contains the refrigerant isobutane (R600a), a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Ensure, therefore, that none of the components of the refrigerant circuit become damaged during transportation and installation of the appliance. If damage to the cooling circuit does occur, do not switch on or connect the appliance to the mains power. If there should be an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from the area and that the room is then 12 thoroughly ventilated. [. . . ] In the case of uneven floors, the height-adjustable feet on the unit can be used to compensate and ensure optimum stability. Ventilation Ensure that there is enough space around the unit so that the air circulation round and behind it is not obstructed. 14 Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Remove the two screws (6) securing the upper hinge plate (5) on the right-hand side. Carefully lift up the door and place it on a suitable surface to protect it from scratches. Take off the white plug (7) and re-position it in the corresponding hole on the right-hand side, pushing it firmly down. Remove the two screws (1) securing the lower hinge plate (2) on the right-hand side. Take out the adjustable foot (4) and re-position it on the right-hand side. Mount the lower hinge plate (2) using both screws (1) in its new position on the left. Ensure that the plate is aligned parallel to the side edge of the unit. Ensure that the hinge pin of the lower hinge plate is inserted into the guide bushing (hole) in the door. Mount the upper hinge plate (5) using both screws (6) in its new position on the left. Ensure that the hinge pin is inserted into the guide bushing (hole) in the door. Close the door and ensure that it is properly aligned before fully tightening the screws of the upper and lower hinge plates. Fit the top panel (9) on the unit and – with the door open – replace the cover plate (8) into the opening on the right-hand side of the front. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The temperature control automatically regulates the temperature inside the different compartments. Min cold setting Normal colder (normal) setting Max coldest setting Note: The operating temperature in the freezer largely depends on factors such as the ambient temperature and that of the food to be newly frozen. It also depends on how often the door is opened and how long it remains open. If necessary, the temperature control setting may be adjusted accordingly. Meat, fish, minced meat) should be divided into smaller portions suitable for use after thawing). € When storing pre-frozen food, strict attention should be paid to the manufacturer’s information provided on the packaging. [. . . ] € The following table lists the possible malfunctions, their probable causes and solutions. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. This guarantee does not affect your statutory rights, nor any legal rights you may have as a consumer under applicable national legislation governing the purchase of goods. If the product fails to operate and needs to be returned, pack it carefully, enclosing your name and address and the reason for return. [. . . ]