User manual SEVERIN KS 9892

[. . . ] ρ The cooling circuit in this appliance contains the refrigerant isobutane (R600a), a natural gas with a high level of environmental compatibility, which is nevertheless flammable. Ensure, therefore, that none of the components of the refrigerant circuit become damaged during transport and installation of the appliance. If damage to the cooling circuit does occur, however, do not switch on or connect the appliance to the mains power. If there is an open fire or any other sources of ignition in the vicinity of the refrigerant gas, make sure it is removed immediately from the area and that the room is then thoroughly ventilated. [. . . ] Warning: Always disconnect the unit from the mains before any maintenance or repair work is carried out. Remove the two threaded bolts (6) securing the upper hinge plate (5) on the right-hand side. Carefully lift up the door and place it on a suitable surface to protect it from scratches. Take off the white plug (7) and re-position it in the corresponding hole on the right-hand side, pushing it firmly down. Remove the two threaded bolts (1) securing the lower hinge plate (2) on the right-hand side. Take out the left-hand adjustable foot (4) and fit it on the opposite side. Mount the lower hinge plate (2) in its new position on the left-hand side, using the threaded bolts (1). Ensure that the hinge plate is aligned parallel to the side edge of the fridge. Ensure that the lower hinge pin is inserted into the corresponding guide bush on the door. Mount the upper hinge plate (5) in its new position on the left-hand side, using the two threaded bolts (6). Ensure that the hinge pin is inserted into the corresponding guide bush in the door. Ensure that the door is in its properly closed position before tightening the bolts holding the lower and upper hinge plates. Open the fridge door, place the top panel (9) on top of the unit and fit the cover plate (8) into the opening on the right-hand side of the top panel. Put the unit back in its intended position and wait for about two hours before connecting it to the mains. Temperature control The unit is re-activated by connecting it to the mains. It is only switched off completely when the plug is removed from the wall socket. The temperature in the refrigerator cabinet can be adjusted by setting the temperature control. Turning the control clockwise will decrease the temperature, while turning it anti-clockwise will increase it. € After switching on, set the temperature control to its maximum setting. 30 minutes, the setting should be changed to a medium position, usually sufficient for home or office use. € Following a power interruption, or if the unit has been disconnected from the mains, there may be a delay of 3 to 5 minutes before the unit automatically switches on again. In position ‘0’, the cooling function is switched off, though the appliance is still connected to the mains. [. . . ] € The following table lists possible malfunctions and their probable causes and solutions. In the event of operational problems, check first whether a solution can be found using this table. If the problem persists, disconnect the appliance from the mains power and contact our Customer Service Department. This can be checked by connecting another electrical device to the socket and checking for function. [. . . ]