User manual SHARP AF-A18CE/A24CE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP AF-A18CE/A24CE. We hope that this SHARP AF-A18CE/A24CE user guide will be useful to you.


SHARP AF-A18CE/A24CE : Download the complete user guide (835 Ko)

You may also download the following manuals related to this product:

   SHARP AF-A18CE/A24CE OPERATION MANUALGB (1358 ko)
   SHARP AF-A18CE/A24CE OPERATION MANUALGB (1358 ko)

Manual abstract: user guide SHARP AF-A18CE/A24CE

Detailed instructions for use are in the User's Guide.

[. . . ] The air conditioner should be installed with a strong external support to minimize noise and vibration, and for the purpose of safe installation, repair, replacement and secure positioning. Avoid installing the air conditioner where it is exposed to direct sunlight. 43. 5~44. 5 cm (17 1/8"~17 1/2") More than 20 cm (8") 8 cm 67~6 ") 6 3/4 /8"~2 (26 3 More than 20 cm(8") 8~20 cm(3"~8") More than 40cm(16") Air outlet Air inlet More than 20cm(8") Air inlet More than 40cm (16") More than 20cm(8") Air inlet Air inlet Air outlet About 1cm (3/8") POWER CABLING GROUNDING WARNING : THIS APPLIANCE MUST BE GROUNDED. Fit a disconnect switch, having a contact separation of at least 3mm in all poles, to the electricity power line. [. . . ] (Fig. 10) (2) Remove the grille (Fig. 11) and the air filter (Fig. 12) from the front panel. Secure the front panel with one short gold screw(1. 2cm/0. 5") (Fig. 12) and replace the air filter and the grille. Front panel back view Fig. 9 Crank shaft Louver link Fig. 10 Grille Air filter Front panel Fig. 11 Fig. 12 E-5 ENGLISH OPERATION INSTRUCTIONS OPERATION INSTRUCTIONS PRECAUTIONS POWER CORD REPLACEMENT WARNING: For replacement, use only the manufacturer specified power cord. Replacemant should be conducted by a qualified technician or a serviceman. Consult your dealer for detailed information concerning replacement of the power cord. WAIT FOR 3 MINUTES BEFORE RESTARTING THE COOLING OPERATION Whenever you turn the air conditioner OFF, wait for at least three (3) minutes before restarting the unit. If you restart the air conditioner within three minutes, a protective device in the unit may cause the air conditioner to shut off. This protective device will prevent cooling operation for about 5 minutes. IF A POWER FAILURE OCCURS DURING OPERATION, MAKE SURE TO TURN OFF THE AIR CONDITIONER After resumption of power supply, restart the air conditioner . If the power was off for less than three minutes, make sure to wait for at least three minutes before restarting the unit. If the air conditioner is not turned off during a power failure, the resumption of power supply will cause excessive voltage. The air conditioner will be over-loaded and will not operate for about 5 minutes. TO STOP THE UNIT, TURN THE SELECTOR KNOB TO THE "OFF" POSITION. ALWAYS USE A FUSE WITH THE PROPER AMP RATING Never use wire, pins or anything other than the proper fuse. In replacing a blown fuse, or if there is the problem of constant fuse blowing, contact your dealer or our service center. VENTILATE THE ROOM PERIODICALLY DURING USE, ESPECIALLY IF GAS APPLIANCES ARE USED. NOTES ON OPERATION POWER SUPPLY VOLTAGE If the power supplied to the unit is not within plus / minus 10 % of the specified rating, the unit may not function and the fuse may blow. OPERATING TEMPERATURE RANGE INDOOR TEMP. A built-in protective device might prevent the unit from operating when used out of this range. Condensation might form on the air outlet when the unit operates continuously in the COOL mode when the humidity is over 80 percent. NOISE LEVEL As the surrounding environment is comparatively silent at night, noise from the air conditioner may be louder at night than in the day time. If you feel that noise of the air conditioner is too loud, switch the "SELECTOR" knob to the "LOW COOL" position. WATER IN THE BOTTOM TRAY Water will be collected at the bottom tray of the unit. Water condenses on the evaporator coil in the front part of the unit and is channeled to the rear where it is picked up by the condenser fan. [. . . ] If your room is too cool, adjust the THERMOSTAT knob to a lower cooling setting. The lever should be set in the LEFT (CLOSED) position during cooling operation. Close all windows and doors for maximum cooling effect. LEFT / RIGHT AIR FLOW ADJUSTMENT LOUVERS DO NOT SWING · Is the crank shaft fit properly into the louver link? [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP AF-A18CE/A24CE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP AF-A18CE/A24CE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.