User manual SHARP AF-Q120PX

[. . . ] Connect the brown wire of the power supply cord to the live terminal, and the grounding wire (green and yellow) to the grounding terminal of the electrical outlet. The remaining wire should be connected to the neutral terminal of the electrical outlet. Grounding wire (green&yellow) Live (brown) Neutral (blue) FUSE For safe, trouble free operation, connect the power cord of the unit to a properly rated independent circuit with a time delay fuse or a circuit breaker. 13 ( AF-A18CE ) ( AF-A24CE ) E-2 INSTALLATION INSTRUCTIONS INSTALLATION WARNING: Turn off and disconnect the unit before working. [. . . ] 6) E-4 INSTALLATION INSTRUCTIONS 6 Slide the chassis back into the cabinet. Secure the chassis to the cabinet using the screw and angle removed in Step 2. Slide the angle to the right until the holes meet, and screw it on to the chassis. 9) Slide the crank shaft into the opening of the louver link at the back of the front panel. 12 E-5 ENGLISH OPERATION INSTRUCTIONS OPERATION INSTRUCTIONS PRECAUTIONS POWER CORD REPLACEMENT WARNING: For replacement, use only the manufacturer specified power cord. replacemant should be conducted by a qualified technician or a serviceman. Consult your dealer for detailed information concerning replacement of the power cord. WAIT FOR 3 MINUTES BEFORE RESTARTING THE COOLING OPERATION Whenever you turn the air conditioner OFF, wait for at least three (3) minutes before restarting the unit. If you restart the air conditioner within three minutes, a protective device in the unit may cause the air conditioner to shut off. This protective device will prevent cooling operation for about 5 minutes. IF A POWER FAILURE OCCURS DURING OPERATION, MAKE SURE TO TURN OFF THE AIR CONDITIONER After resumption of power supply, restart the air conditioner . Experiments may be needed in order to find out the most suitable setting. aUTO SWING SWITCH Use to activate automatic louver movement during LOW COOL , MED COOL and HIGH COOL. Adjust the louvers to change the direction of air flow for uniform and efficient cooling of the room. Set the AUTO SWING switch ON ( ), and the Left/Right air flow adjustment louvers will swing continuously to provide better circulation of cool air. The louvers will be stopped at the position when the switch is turned off. You can also use the switch to adjust the Left/Right air flow adjustment louvers to the desired position. Never attempt to move the Left/Right air flow adjustment louvers manually, or manually force the louver movement to stop during swing operation. The AUTO SWING switch will not activate the louvers when the SELECTOR KNOB is set to FAN. UP/DOWN AIR FLOW ADJUSTMENT Airflow direction can be adjusted by moving the airflow adjustment louvers upward or downward. To avoid condensation on the louvers, please do not adjust these louvers to extremely downward position during LOW COOL, MED COOL and HIGH COOL operation modes for a long time. VENTILATION LEVER If air in your room is stale, set the VENTILATION lever to the RIGHT (OPEN) position. [. . . ] To avoid damaging the unit, do not use hot water of over 50°C when cleaning. oILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY The compressor is permanently lubricated and is hermetically sealed. If the power was off for less than 3 minutes, and you restart the air conditioner within 3 minutes, a protective device may cause the air conditioner to shut off, preventing cooling operation for about 5 minutes. If your room is too warm, adjust the THERMOSTAT knob to a higher cooling setting. [. . . ]