User manual SHARP AY-A12GR

[. . . ] Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. When using the air conditioner for infants, children, elderly, bedridden, or disabled people make sure the room temperature is suitable for those in the room. Inserting objects can result in injury due to the high speed rotation of internal fans. [. . . ] This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. If the timers were set before a power failure, they will need to be re-set after power recovery. In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit. When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. ⷠAfter de-icing is completed, the unit automatically resumes operation in the HEAT mode. The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠIt takes time to warm up and heat the entire room because of the forced air circulation system. Below are some simple ways to save energy when you use your air conditioner. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with the fan speed set to "SOFT( )" for an extended period of time. Timer duration can be set from a minimum half an hour (30 minutes) to a maximum of 12 hours. 5 hours, you can set in half-hour (30-minute) increments, and from 10 to 12 hours, in 1-hour increments. TIPS ABOUT TIMER OFF OPERATION When the TIMER OFF is set, the temperature setting is automatically adjusted to prevent the room from becoming excessively cold while you sleep. (Auto Sleep function) COOL/DRY MODE: · One hour after the timer operation begins, the temperature setting rises 1°C higher than the original temperature setting. hEAT MODE: · One hour after the timer operation begins, the temperature setting drops 3°C lower than the original temperature setting. Timer duration can be set from a minimum of half an hour (30 minutes) to a maximum of 12 hours. [. . . ] ⷠThe fan speed and temperature setting are set to AUTO. This is the smell of ozone generated from the Plasmacluster Ion generator. The ozone concentration is very small, posing no adverse effect on your health. The ozone discharged into the air rapidly decomposes, and its density in the room will not increase. [. . . ]