User manual SHARP AY-XP26FR-N

[. . . ] It means that used electrical and electronic products should not be mixed with general household waste. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. By disposing of this product correctly you will help ensure that the waste undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health which could otherwise arise due to inappropriate waste handling. In other Countries outside the EU If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal. [. . . ] â· When you replace the batteries, always change both batteries, and make sure they are the same type. â· If the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. â· If you will not be using the unit for a long time, remove the batteries from the remote control. Point the remote control towards the unit's signal receiver window and press the desired button. â· Make sure there is no curtain or other object between the remote control and the unit. â· The remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. â· Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. â· The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. â· Do not leave the remote control in direct sunlight or near a heater. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. SELF CLEAN operation will provide effect to reduce the growth mold fungus, and to dry inside of the air conditioner unit with Plasmacluster ions. The red OPERATION lamp ( ), the green SELF CLEAN lamp ( ) and the blue PLASMACLUSTER lamp on the unit will light up. â· The red OPERATION lamp ( ), the green SELF CLEAN lamp ( ) and the blue PLASMACLUSTER lamp on the unit will turn off. You cannot set the temperature, fan speed, air flow direction or timer setting during the SELF CLEAN operation. When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. â· The red OPERATION lamp ( ) and the orange TIMER lamp ( ) on the unit will turn off. If the ONE-HOUR OFF TIMER is set while the unit is not operating, the unit will operate for an hour at the formerly set condition. [. . . ] You cannot programmed the ON-TIMER and OFF-TIMER to operate the unit at different temperatures or other settings. â· Either timer can be programmed to activate prior the other. The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. â· The fan speed and temperature setting are set to AUTO. [. . . ]