User manual SHARP CD-MPX200H

[. . . ] Z Audio-visual material may consist of copyrighted works which must not be recorded without the authority of the owner of the copyright. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] If you make a mistake, the programmed tracks can be cleared by pressing the CLEAR button. Each time the button is pressed, one track will be cleared, beginning with the last track programmed. Press the DISC SKIP button 3 times for the unit to read the information of each disc to programme them. The new tracks will be stored after the last track of the original programme. Z Even if you press the ON/STAND-BY button to enter the stand-by mode or the function is changed from CD/VIDEO CD (CD) to another, the programmed selections will not be cleared. You can play back a desired track by selecting one from the 9 displayed tracks on the screen. Z Each time a track is displayed, you can hear the first several seconds of the track. Z When the last track on the third disc has finished playing, the unit will stop automatically. When there are more than 9 tracks on the video CD: Each press of the PRESET (NEXT ) button will display the next 9 tracks. You can look at the sections and select the scene you want to start watching from. This function is convenient when you want to start from the middle of an undivided track, for example, a movie. Z If more than 9 bookmarks are created, bookmarks will be erased in the order they were created. This function is to restart playback from the point where it has stopped. Z Resume play cannot be activated when the function is changed from CD/VIDEO CD (CD) to another or the unit is set to the power stand-by mode. Z Resume play cannot be performed whilst opening the disc tray or after changing the disc. Usually this unit detects the video CD and plays back pictures and sounds. In case this unit fails to judge it correctly, you can play back the video CD manually. Each time the OSD (OSD ON/OFF) button is pressed during playback or in the stop mode, the display will change as follows: Z Whilst in the "VCD ON" state, you cannot play back audio CDs. You can check the operation of the main unit by the on-screen display. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. Z Be sure to place 8 cm (3") CD(s) in the middle of the disc positions. Total number of tracks on the CD whose number is flashing Total playing time of the CD whose number is flashing To select the CD you want to listen to first, press the DISC SKIP button. [. . . ] Z Once the time is set, the setting will be retained until a new time is entered. Z When performing timer playback or recording using another unit connected to the VIDEO/AUX sockets, select "VIDEO/AUX" in step 2. At this time, only this unit will be turned on or enter the power stand-by mode automatically. It will enter the power stand-by mode when the end of the recording tape is reached in timer recording or 1 hour after the playback starts in timer playback. [. . . ]