User manual SHARP DK-A1

[. . . ] To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. MUSIC SYSTEM FOR iPod® MODEL DK-A1 DK-A1BK OPERATION MANUAL N FUNCTIO CLOCK / SNOOZE R DIMME VOL SLEEP ALARM Y DISPLA E SOUND /DEMO PLAY MODE TUNING CLEAR EQ MEMOR Y The illustrations printed in this operation manual are for the model DK-A1. Accessories Please confirm that the following accessories are included. Remote control 1 FM antenna 1 AM loop antenna 1 QANTW0004AW09 (DK-A1) RRMCGA106AWSA (DK-A1) (QANTL0010AWZZ) 92LFANT1535A (DK-A1BK) RRMCGA107AWSA (DK-A1BK) iPod is a registered trademark of Apple Computer, Inc. AC power cord 1 QACCD0025AW09 (DK-A1) QACCD0025AWZZ (DK-A1BK) iPod adaptor 8 UACRTA007AW01 (DK-A1) UACRTA008AW01 (DK-A1BK) Note: This product is not compatible with MTP and AAC file systems. Note: Only the above accessories are included. DK-A1 DK-A1BK SPECIAL NOTES NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To readjust the clock: Perform "Setting the clock" from step 1. To change the 12-hour or 24-hour display: 1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 23 for details. ] 2 Perform "Setting the clock" from step 1. 2 Slide the ST switch to -1 to turn the clock back 1 hour. 3 Press the or button to adjust the hour and then press the CLOCK button. Press the or button once to advance the time by 1 hour. Hold it down to advance continuously. 13 Basic Operation 1 2 Press the CLOCK button for more than 2 seconds. [When the power is on] Press DISPLAY button on remote control to toggle between the function information and clock display. DK-A1 DK-A1BK Listening to the iPod Supported iPod models: iPod nano (software 1. 0 above) iPod photo (software 1. 0 above) iPod mini (software 1. 2 above) 5th Generation iPod (software 1. 0 above) (Dock connector equipped Click Wheel model) 4th Generation iPod (software 3. 0. 2 above) (Dock connector equipped Click Wheel model) 3rd Generation iPod (software 2. 2 above) (Dock connector equipped Click Wheel model) Caution: Please update your iPod unit to the latest software version before using it. Please visit Apple's homepage to download the latest version for your iPod. The iPod unit can not be charged while the main unit is in the stand-by mode. Auto power on function: When you press any of the following buttons, the unit turns on. iPod button (main unit): The unit turns on and the iPod function is activated. / button (main unit and remote control): The unit turns on and playback of the last function will start (iPod, TUNER, AUX). iPod adaptor connection Choose the iPod adaptor that fits your iPod. If your iPod is not mentioned below, an iPod adaptor may have been included with your iPod unit. The number (3-10) shows which iPod fits 7 iPod Adaptor No. 3 4 5 6 7 6 7 8 9 10 iPod Description iPod mini 4G iPod & U2 iPod 4G iPod iPod photo & Color U2 iPod iPod photo iPod with color display iPod with color display iPod nano iPod (10/12/05 w/video) iPod (10/12/05 w/video) Capacity 4GB & 6GB 20GB 40GB 20GB & 30GB 40GB & 60GB 20GB 60GB 2GB & 4GB 30GB 60GB iPod Note: If you have an iPod that does not have an iPod connector, you can use an audio cable to connect it to the AUX IN jacks. 14 DK-A1 DK-A1BK 1. Push the iPod sliding door until end. To remove iPod adaptor Hold this tip and pull as direction shown to remove adaptor. EQ iPod AUX + E SO UN E SO UN 2. iPod (bottom) iPod iPod playback 1 2 3 Press the ON/STAND-BY button to turn the power on. Press the iPod button on main unit once or FUNCTION button on remote control repeatedly to select iPod function. iPod iPod adaptor iPod adaptor iPod dock EQ iPod connector EQ iPod AUX iPod AUX - + E SO UN - + E SO UND 4 Press the / button to start playback. 15 iPod Dock connector Open the iPod terminal door and insert iPod unit in iPod dock of main unit. DK-A1 DK-A1BK Listening to the iPod (continued) Various iPod functions Function Play Main unit Remote control Operation Press in the pause mode. iPod operation The operations described below depend on the generation iPod you are using. System on operation When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including alarm function). System off (stand-by operation) When the main unit is turned to stand-by mode, the docked iPod unit will automatically turn to stand-by mode (including alarm and sleep function). iPod playback detection function Once play button on iPod unit is pressed, the unit will automatically change to iPod function overriding the previous function selected. Caution: Unplug all accessories for the iPod before inserting it into the iPod dock. Pause Press in the playback mode. Track up/ down Fast forward/ reverse Press in the playback or pause mode. If you press the button in the pause mode, press the / button to start the desired track. ____ DISPLAY iPod Display iPod back light ON. Repeat ____ PLAY MODE Press to toggle repeat mode. Shuffle ____ PLAY MODE Press and hold down to toggle shuffle mode. 16 Listening to the radio Tuning DK-A1 DK-A1BK 1 2 3 iPod AUX TUNER CLOCK SNOOZE DIMMER ALARM ON/OFF Press the ON/STAND-BY button to turn the power on. [. . . ] There may be some deviations from these values in individual units. DK-A1 DK-A1BK General Power source Power consumption Output power AC 120 V, 60 Hz 29 Watts Before transporting the unit Remove the iPod from the unit. Carrying the unit with iPod left docked might damage both the unit and the iPod. Maintenance Cleaning the cabinet Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth. Caution: Do not use chemicals for cleaning (gasoline, paint thinner, etc. ). It may cause malfunctions. Tuner Frequency range FM: 87. 5 - 108. 0 MHz AM: 530 - 1, 720 kHz 23 References Caution: This operation will erase all data stored in memory including clock, alarm settings and tuner preset. Front Speakers: 2 watts minimum RMS per channel into 12 ohms from 50 Hz to 20 KHz, 10% total harmonic distortion. [. . . ]