User manual SHARP FO-135

[. . . ] For example, do not use this product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Unplug the product from the power outlet and consult a qualified service representative if any of the following situations occur: - Liquid has been spilled into the product or the product has been exposed to rain or water. Do not allow anything to rest on the power cord, and do not install the product where people may walk on the power cord. The AC adapter must only be connected to a 220 - 240 V, 50/60 Hz outlet. [. . . ] Connecting it to any other kind of outlet will damage the machine and void the warranty. Never insert objects of any kind into slots or openings on the product. If an object falls into the product that you cannot remove, unplug the product and consult a qualified service representative. The product could be seriously damaged if it falls. Battery Use only the battery specified in this manual. Corrosive fluid may leak out and cause injury or burns to the eyes and skin. In case of contact with eyes, flush with clean water (do not rub), and seek medical attention immediately. Do not store or carry the battery with other metal objects such as keys or pins. The battery may explode. Health care facilities and equipment Radio frequency energy emitted from the cordless handset equipment may cause medical equipment to malfunction. Verify that any personal medical equipment you are using is adequately shielded from external radio frequency energy before using the cordless handset equipment. (If you need to use a number that is already in use, delete the cordless handset that uses that number as explained on page 10. ) Note: If you pause more than one minute between any of the above steps, registration will be canceled. 5 English Note: If you take no action for one minute during the registration procedure, the procedure will be canceled. In this case, start from Step 1 again. The fax machine is identified by the number "0", and the cordless handset that was included with the fax is identified by the number "1". Entering a Name for the Cordless Handset Enter a name for the cordless handset in the fax machine. The fax machine will transmit the name that you enter to your cordless handset. The name will appear in the cordless handset's display. 1 2 3 4 Press FUNCTION once and the fax machine. Press once and 3 times on Fax machine display: ENTRY MODE once. HS NAME SET Press once. 1=SET, 2=CLEAR Press 1 to select SET. SELECT HS NO. ENTER (1-4) 5 Enter the number of the cordless handset for which you wish to enter a name. Example: Example: Cordless handset 2 HS2 SELECTED 2 6 6 Enter the name by pressing number keys for each letter as shown in the chart below. Example: BILL = 22 444 555 SPACE = A= B= C= D= E= F= G= H= I= J= K= L= M= 555 N= O= P= Q= R= S= T= U= V= X= Y= Z= To enter two letters in succession that require the same key, press after entering the first letter. To clear a mistake, press lower case letter appears. SPEAKER . To enter a lower case letter, continue pressing the key for the letter until the To enter one of the following symbols, press or )( repeatedly: . /!"#$%&'()++, -:;<=>?@[¥]^_'{|} 7 8 Press START/MEMORY to store the name. Display: OWN NUMBER SET The handset number and name appear in the standby display: Press STOP to exit. HANDSET2 BILL Note: If other cordless handsets for the FO-CC500 fax machine are in use when the above procedure is performed, the name of the new cordless handset will not be transmitted to those cordless handsets (the name will not appear by the cordless handset number when INTER COM is pressed on those cordless handsets to use the intercom and call transfer functions). The stored name automatically appears in the display in Step 6, so simply press START/MEMORY to retransmit the name to those cordless handsets, and then exit the procedure with Step 8. 7 English W= The cordless handset is now ready to be used! For information on operating the cordless handset, see your FO-CC500 fax machine manual. Maintenance Replacing the Cordless Handset Battery Like any other battery, the rechargeable battery will eventually wear out. The battery can normally be used for about two years, although this will vary depending on the conditions of use. If you find that LOW BATTERY appears in the cordless handset display soon after the battery is charged, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3. 6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced. [. . . ] The battery can normally be used for about two years, although this will vary depending on the conditions of use. If you find that LOW BATTERY appears in the cordless handset display soon after the battery is charged, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3. 6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. Battery disposal The battery pack contains a Nickel Metal Hydride battery. [. . . ]