User manual SHARP FO-2200

[. . . ] As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. Do not disassemble this machine or attempt any procedures not described in this manual. For example, do not use the machine near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. [. . . ] You will also need to transmit the page which was being scanned when the memory filled up. When the reception mode is set to TEL/FAX, your fax machine automatically answers all calls on two rings. After answering, your fax monitors the line for about five seconds to see if a fax tone is being sent. If your fax machine detects a fax tone (this means that the call is an If your fax machine doesn't detect a fax tone (this means that the call is a Voice call or manually dialled fax), it will make a ringing sound (called pseudo ringing) for 15 seconds to alert you to answer. If you don't answer within this time, your fax will send a fax tone to the other machine to allow the calling party to send a fax manually if they desire. Note: Only the fax will alert you to voice calls or manually dialled faxes by pseudo ringing. An extension phone connected to the same line will not ring after the connection has been established. If desired, you can change the duration of pseudo ringing in Tel/Fax mode. Enter a number as follows for the desired duration: Mode, your fax will automatically receive voice and fax messages if you have connected an answering machine to the fax machine. When the reception mode is set to FAX, the fax machine will automatically answer all calls on two rings and receive incoming faxes. If you pick up the handset before the machine answers, you can talk to the Changing the number of rings If desired, you can change the number of rings on which the fax machine answers incoming calls in FAX and TEL/FAX mode. To avoid using memory, use STANDARD or FINE for the resolution, 100% for the enlarge/reduce setting, and make only one copy per original. When making a copy of a document that is longer than the printing paper, use the copy cut-off setting to select whether the remaining part of the document will be cut off or printed on a second page. Press 1 to set copy cut-off to YES (the remaining part of the document will not be printed), or 2 to set copy cut-off to NO (the remaining part will be printed on a second page). If desired, you can connect an answering machine to your fax machine's TEL. This will allow you to receive both voice messages and faxes when you are out. The outgoing message (OGM) of your answering machine should be changed to inform callers who want to send a fax to press their Start key. Please leave a message after the beep or press your facsimile Start key to send a fax. Too long, you may have difficulty receiving faxes sent by automatic dialling. If your outgoing message must be longer than 10 seconds, leave a pause Of about four seconds at the beginning of the message. This will give your fax a chance to detect fax tones sent when automatic dialling is used. Your answering machine must be set to answer on a maximum of two rings. [. . . ] aDD PAPER & / PRESS START KEY (alternating messages) Check the printing paper. If there is paper in the tray, make sure it is inserted correctly (take out the stack, align the edges evenly, and then reinsert it in the tray) and then press the START/MEMORY key. These alternating messages appear when there is a problem in the print compartment that prevents printing. Check to see if the imaging film is not loaded properly or if it has been used up and needs replacement. [. . . ]