User manual SHARP FO-K01

[. . . ] 4 hours (240 minutes) (at room temp. ) Battery life in standby mode Approx. 2 days with one full charge (at room temperature) Battery life (both normal and in standby mode) may vary depending on usage, range from base machine, and environmental conditions such as temperature. 1 English As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. [. . . ] Excessive heating may result, causing a fire. Installing and Charging the Battery 1 Connect the battery connector , and then place the battery pack in the cordless handset. Red Black Red Black 2 Place the battery cover on the cordless handset, making sure it snaps firmly into place. · Make sure the wires are not caught or pinched by the cover. 3 English 3 Place the cordless handset in the charger with the dial pad facing forward. · Important!The dial pad must face forward, or the battery will not charge. · While charging the first time, the display may show PLEASE REGISTER. Be sure to let the battery charge for 10 hours, and then register the cordless handset as explained on the following page. Charge the battery at least 10 hours the first time! The cordless handset and charger may feel warm while charging. When not using the cordless handset, keep it in the charger to ensure that it is always charged. When the battery needs charging, LOW BATTERY will appear in the display and you will hear beeps during a phone conversation. Note: If the battery is extremely low, nothing may appear in the display during the first several minutes that the cordless handset is in the charger. Walkie-Talkie capability Two cordless handsets can be used for walkie-talkie like communication. The talking range of the cordless handsets is 360 m (line of sight; talking range may decrease depending on transmission conditions), and there is no need to be in the talking range of the fax machine. Talking range (distance from fax machine) for phone calls The talking range of the cordless handset for phone calls is approximately 360 m (line of sight; talking range may decrease depending on transmission conditions) from the fax machine. If you hear noise or interference while talking, move closer to the fax machine. When outside the talking range, OUT OF RANGE appears in the display. If you move out of the talking range while talking on the cordless handset, the handset will beep and you may hear interference. Aluminum sash Metal Reinforced concrete Large metal objects, metal structures, and thick walls reduce the talking range. 4 Registering the Cordless Handset After the initial charging, the cordless handset display shows: PLEASE REGISTER To use the cordless handset, you must first register it with the fax machine. 1 On the cordless handset, hold down INTER COM Cordless handset display: until the display at right appears. MODE SELECT 1: HS ENTRY 2: HS DELETE 2 Press 1 on the cordless handset. HS ENTRY MODE 3 Fax machine display: On the fax machine, hold down until the display at right appears. INTERCOM MODE SELECT 1: HS ENTRY 2: HS DELETE 4 5 Press 1 on the fax machine. PRESS HS NUMBER On the fax machine, enter a number from 2 to 4. This number identifies the cordless handset. Example: "2" is selected HS2 ENTERED · This completes the registration procedure. Both displays return to the normal standby display Note: If ALREADY STORED appears in the display, the number you selected has already been assigned to another cordless handset. (If you need to use a number that is already in use, delete the cordless handset that uses that number as explained on page 10. ) Note: If you pause more than one minute between any of the above steps, registration will be canceled. 5 English Note: If you take no action for one minute during the registration procedure, the procedure will be canceled. [. . . ] STOP ( ) () FO-CC500 : ) . ( ) LOW BATTERY : , ) Sharp UX-BA01 : ) mAh ( ) Ni-MH ( . STOP START/MEMORY ( ) : MODE SELECT 1: HS ENTRY 2: HS DELETE INTER COM . [. . . ]