User manual SHARP FU-28H

[. . . ] Do not use the air purifier if the power cord or plug is damaged or the connection to the wall outlet is loose. ⷠDo not insert fingers or foreign objects into the intake or air outlet. When removing the power plug, always hold the plug and never pull the cord. ⷠDo not use this air purifier near gas appliances or fireplaces. [. . . ] This improves the cleaning performance and causes Plasmacluster ions to spread throughout the room. It is recommended to use the unit in a room where the temperature is in the range of 0 - 35C°. Avoid locations where the unit is exposed to condensation, due to drastic temperature changes. The unit cannot be mounted if there is insufficient spacing around the bracket. Center line of Wall mounting bracket Center line of main unit 16mm Screw Holes 60mm 70cm or more from side wall 3mm Wall mounting bracket 330mm 70cm or more from side wall Screw Holes Center line of main unit Size of main unit Before fixing the wall mounting bracket, make sure there is nothing that could obstruct installation of the unit. Then fix the wall mounting bracket through screw holes with the supplied wood screws. ⷠInstall the unit on a wall, wooden pillar, crosspiece or the like that is flat and strong enough. ⷠIf the wall is weak or made of concrete, have the unit installed by a specialist such as an electric appliance store. ⷠAvoid locations near inverter lamps or where the unit is exposed to direct sunlight. Mount the bracket using the included wood screws so that it is maintained level. Drill holes of at least 35 mm depth and 5 mm diameter into the wall, drive in Fisher plugs, and fix the unit with wood screws. To install the unit on a wooden wall that is less than 10 mm thick, consult your dealer and have them confirm the strength of the wall before installation. ⷠInstall the unit on a wall, wooden pillar, crosspiece, etc. Make sure that the unit is installed in an upright position, without leaning to the right or left. Before starting the wall installation, be sure to remove the front panel and filter frame. (Refer to E-6) Place the unit face down, and insert the power cord into the power cord adjusting guide so as to adjust it to the measured length. To avoid scratching or damaging the unit, place it on a soft piece of cloth until it is installed on the wall. ⷠDo not lead the power cord together with other cord and do not twist it. ) 8 cm above both ends of the wall mounting Lift up the that the hooking holes on the 4 the marks, unit sothe unit onto the wall mountingunit are aligned with hook bracket and slide it to the right. When positioned correctly, the unit will move down slightly until it engages. Alignment with the left hooking holes Make sure that the claws of the unit are hooked in properly. ⷠMake sure that the power cord is not caught in the unit. [. . . ] * The applicable floor surface area is the surface area for when operating the unit in MAX fan level. (JEM 1467, The Japan Electrical Manufacturers' Association) Applicable floor surface area indicates the space where a certain amount of dust pollution can be removed in 30 minutes. About the reduction of standby power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 1. For the conservation of energy, remove the power plug when not using the unit. [. . . ]