User manual SHARP HT-M700H

[. . . ] G Quest'apparecchio conforme ai requisiti delle direttive 89/ 336/EEC e 73/23/EEC, come emendata dalla direttiva 93/68/ EEC. G Dichiarazione di conformit La societ SHARP ELECTRONICS EUROPE GmbH dichiara che il prodotto SHARP HOME CINEMA CON DVD HT-M700H costruito MINI SISTEMI CD-XP300H in conformit alle prescrizioni del D. M. n548 del 28/8/95, pubblicato sulla G. U. n301 del 28/12/95 ed in particolare conforme a quanto indicato nell'art. G Dit apparaat voldoet aan de eisen van de richtlijnen 89/336/ EEG en 73/23/EEG, gewijzigd door 93/68/EEG. G Este equipamento obedece s exigncias das directivas 89/ 336/CEE e 73/23/CEE, na sua verso corrigida pela directiva 93/68/CEE. [. . . ] Do not connect other equipment (VCR, etc. ) between the TV and the main unit. Insert the plugs fully to avoid fuzzy pictures or noise. Press the ON/STAND-BY button. If the power does not turn on, check if the AC power lead is plugged in properly. To set the unit to stand-by mode: Press the ON/STAND-BY button again. Preparation for Use 8 E-18 05/5/27 HT-M700H(H)E2. fm TINSZA069SJZZ HT-M700H Remote control Battery installation Use 2 "AAA" size batteries (UM-4, R03, HP-16 or similar). Insert the batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them toward the battery terminals. Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Keep the remote control away from moisture, heat, shock, and vibrations. ENGLISH 3 Test of the remote control Preparation for Use Check the remote control after checking all the connections. The remote control can be used within the range shown below: Press the ON/STAND-BY button. During an operation, " " may appear indicating that the operation is disabled by the disc. Some CD-R/CD-RW may not play properly due to the status of the disc or equipment used for recording. Caution: A disc does not play if damaged, dirty or loaded upside down. When attempting to play discs with scratches or of a different region number, or unplayable or restricted (*1) discs, an error message will appear on the TV display and the disc will not play. (*1) Viewing is prohibited on some DVDs according to the audience age. ENGLISH To resume playback after stopping (resume play) You can resume playback from the point playback is stopped. 1 Whilst the disc is playing, press the button. The system stores the point you stopped. Pre-Stop 2 To restart play, press the (DVD/CD ) button. Play Playback resumes from the point you left off. To cancel resume play: Press the button again. Stop DVD Operation Notes: The resume play feature is disabled on some discs. Depending on the disc, playback may resume slightly before the position where it was stopped. E-23 05/5/27 HT-M700H(H)E3. fm TINSZA069SJZZ Basic operation Fast forward/Fast reverse (search) You can search the desired point as you play the disc. HT-M700H ENGLISH 1 Whilst a disc is playing, hold down the or button for 2 seconds or more. Fast Forward 2x The scanning speed will change as follows at each press of the button. The speed changes as follows on DVD/super video CD/video CD/audio CD/DivX disc: To locate the beginning of a chapter/track (skip) You can skip the current chapter (track) to the next or previous. On DVD/Super Video CD/Video CD/Audio CD: Press the button to skip to the beginning of the current chapter (track). Press the button again to skip to the beginning of the previous chapter (track). [. . . ] Is the unit turned on? ENGLISH General Symptom The power is not turned on. Is the TV input switched on? References 8 E-62 05/5/27 HT-M700H(H)E7. fm TINSZA069SJZZ HT-M700H Troubleshooting chart (continued) Tuner Symptom The radio makes unusual noises continuously. Move the aerial away from the AC power lead if it's located nearby. Did you remove the plug from the wall socket, or did a power failure occur? [. . . ]