User manual SHARP HT-SB40_EN

[. . . ] ENGLISH MODEL Special Notes FCC Radiation Exposure Statement This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. It must not be co-located or operating in conjunction with any other antenna or transmitter. This device must accept any interference received, including interference that may cause undesired operation. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and person’s body (excluding extremities: hands, wrists, feet and ankles. [. . . ] When inserting or removing the battery, push them toward the battery terminals. Method 1 This connection is for HDMI TV with ARC (Audio Return Channel). Notes: ● Refer to the operation manual of the equipment to be connected. — Connecting via this method may disable TV internal speakers. — In some cases, a small background noise could emit from the sound bar, when you use the RCA audio output terminal connection from a TV-Set/DVD/Blu-ray Disc Player. In such case, please change the connection to the HDMI/ARC or headphone terminal connection. This effect depends on the used TV/DVD/Blu-ray Disc Player-Brand, model and age, and it is not a quality matter from the sound bar. To HDMI (TV ARC) input terminal Make sure to enable the HDMI CEC when making HDMI connection. Caution: ● Remove the battery if the sound bar will not be used for a long period of time. — Installing the battery incorrectly may cause the sound bar to malfunction. — Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: ● Replace the battery if the operating distance is reduced or if the operation becomes erratic. — Periodically clean the transmitter on the remote control and the sensor on the sound bar with a soft cloth. — Exposing the sensor on the sound bar to strong light may interfere with operation. — Keep the remote control away from moisture, heat, shock, and vibrations. To turn the power on Press the ON/STAND-BY button on the sound bar or the remote control. — The power turns on and the subwoofer indicator turns blue. If the power does not turn on, check whether the AC power cord is plugged in properly. — The system will automatically power on if TV or similar component which supports HDMI CEC, is turned on. To set the sound bar to stand-by mode: Press the ON/STAND-BY button again on the main unit or the remote control and the subwoofer indicator turns red. Notes: ● A slight audio delay after TV is turned ON does not ● “AQUOS VCR DVD player Subwoofer To HDMI output terminal Place the system as shown. Remove the protective film covering the sound bar and subwoofer before turn on the system. [. . . ] The sound bar will enter the power stand-by mode automatically if no signal is detected after the preset time has elapsed. Notes: ● APC (Auto Power Off Control) is only applicable for TV ARC, OPTICAL and AUDIO IN input function. — This system will automatically power off if TV or similar component which supports HDMI CEC is turned off. — During OPTICAL input function, if you mute or pause the playback (depending on the connected component), APC function wll be activated. [. . . ]