User manual SHARP JX-735

[. . . ] 1 2 3 4 5 6 Original cover Original table Operation panel Paper output tray Front cover Paper tray 7 8 9 10 Paper guide Power switch Power cord socket Printer interfaces (JX-735 only) 11 Paper release lever 12 13 14 15 Drum cartridge Drum cartridge handle TD cartridge TD cartridge handle This copier has been designed to provide intuitive operating ease while requiring a minimum amount of space. To get full use of all copier features, be sure to familiarize yourself with this manual and the copier. For quick reference during copier use, keep this manual in a handy location. The JX-735 can be used as a copier and as a laser printer while the AL-800 can be used only as a copier. [. . . ] Be careful not to touch the fusing unit when removing the drum cartridge. Remove the new drum cartridge from the plastic bag and set it down on a clean, uncluttered and level surface. The new drum cartridge is sealed with a sheet of black protective paper to shield the drum from light. To prevent damage to the drum surface, do not remove the protective paper until you have inserted the cartridge into the copier. Using both hands hold the tabs on the new drum cartridge between your thumb and index finger, place the two projections on both ends of the cartridge along the guides, and gently insert the cartridge in the direction indicated by the arrow. Carefully remove the sheet of black protective paper from the drum cartridge, making sure not to leave any torn pieces of paper in the copier. Pressing and holding down both the exposure mode selector key and clear (>) key, close the front cover. Continue to hold down these keys for five seconds (drum initialization processing). Drum cartridge life To find out how many more copies can be made before the 20, 000 marks is reached, follow the procedure described below. Press and hold down the light ({) and dark ( }) keys simultaneously for more than 5 seconds until all the alarm indicators (w, t, s ) blink and "­ ­" appears in the display. Press and hold down the clear (>) key for more than 5 seconds to find out how many more copies can be made. The paper to be used for placing the TD cartridge and drum cartridge may be soiled due to toner, etc. The paper for placing the drum cartridge must be enough large to cover the surface of the cartridge (green portion) and must be foldable in half. Gently pull the drum cartridge out and wrap the removed drum cartridge in the paper which was prepared in step 5 so that the green drum section is shielded from light. Remove the misfed paper by holding the edge of the paper nearest you and pulling it gently in a straight line. Remove the misfed paper from the exit area by holding the edge of the paper nearest you and pulling it gently in a straight line. Do not pull the misfed paper too hard with the front cover closed, as you may tear it or damage the printing mechanism. If any problem occurs, check the list below before contacting the Sharp Service Center. If the copier is not used for long time, remove the paper from the paper tray and store it in its wrapper in a dry location. Copy and print quality problems The causes listed in the table below are probable causes only, and may not represent all of the possible cases which may occur under actual operating conditions. If you experience a problem which does not seem to fall under any of the cases listed in this table, or if you are concerned about any other aspect of copying and printing operation, contact your SHARP service center. This manual tells you how to set up, operate and maintain your new printer, and contains advice on how to get the best performance from the printer. [. . . ] The area inside the margins then becomes the "printable area". The Windows Printer Driver specifies the minimum values that you can set for these page margins. These minimum margin settings vary depending on whether you are printing from a Windows application or from a non-Windows application in PCL emulation mode. The following illustration and tables show the minimum settings that can be made in your software applications in both Windows and PCL modes. [. . . ]