User manual SHARP LC-13C2E

[. . . ] This equipment complies with the requirements of Directive 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type. [. . . ] A green indicator lights when the power is on and a red indicator lights when in the standby mode (the indicator will not light when the main power is off). Fundamentally, this operation manual provides a description based on operation using the remote control. END, Status Display Turns on the status display when the menu is not displayed. The power/standby indicator instantaneously changes from red to green and the main unit is turned on. MAIN POWER Note: s The display time of the on-screen indicators can be selected with "Onscreen time" for the "On-screen display" menu item in the TV menu (see page 36). AV1: Select this when viewing the signals from the video equipment connected to the AV-IN 1 terminal. AV2: Select this when viewing the signals from the video equipment connected to the AV-IN 2 terminals using the VIDEO terminal for video input. AVS: Select this when viewing the signals from the video equipment connected to the AV-IN 2 terminals using the S-VIDEO terminal for video input. To turn the LCD TV back on You can select channels using Channel Select or CH ( )/( ). To handle the increasing number of channels available, this LCD TV set allows you to select up to 200 channels (0 to 199). When selecting the channel using Channel Select, finish inputting the channel number by holding down the button for the last digit for a moment. Press ]/[ to select the item, and then press </> to make the adjustment. You can also use Channel Select to adjust the "Channel" and "Frequency" items. If you press YELLOW, all subsequent programmes including the marked one move one programme position back. When YELLOW is pressed, a free programme position is inserted at the current cursor position. If you want to erase programmes in a connected range, select the programme at the beginning of the desired range. Note: s See page 29 for information on how to use the "Decoder programmes" item. Repeat the same procedure if you want to specify other decoder programmes. Press ]/[ to select "Sound from AV1", and then press </> to select the desired sound source. 196 The influence of the AV control voltage and of fast blank at programme positions from 1 to 196 can be set. Notes: s If the item concerned is set to "yes", the appropriate picture is through-connected at all programme positions from 1 to 196 when a control voltage/an RGB signal is applied. The Child Lock function blocks the viewing of any channel for which the child lock has been set. [. . . ] [4] Using the TOP table When TOP Teletext is being broadcast, you can display the TOP table with the current programme data if one exist. You can display the desired subpage by directly inputting a four-digit subpage number with number keys. With the "Character set" screen displayed, press ]/[ to select the desired character set, and then press OK. Notes: s To obtain the correct sub-title in other countries (page 150 default), it is necessary to input the transmittingstation-dependent numbers for these pages beforehand. [. . . ]