User manual SHARP MD-DR470

[. . . ] MD-DR470H ENGLISH Introduction Thank you for purchasing this SHARP product. It will guide you in operating your SHARP product. ENGLISH Important Introduction Contents -Introduction/Contents!65 - 66 E-1 02/12/18 MDDR470_SEEG_E. fm Special Notes " " " " " US and foreign patents licensed from Dolby Laboratories. The AC adaptor supplied with the MD-DR470H must not be used with other equipment. [. . . ] Press the REC button. 4 To perform group recording, hold down the GROUP button for 2 seconds or more so that "GR" is lit. When group recording is not performed, hold down the GROUP button for 2 seconds or more so that "GR" goes out. To the MIC IN socket 5 6 7 8 9 Press the or level (page 17). button to adjust the recording Press the MENU button. The unit enters the menu select mode. Select "REC MODE" by pressing the ton and press the MENU button. or but- Select the recording mode (step 3, page 32) and press the MENU button. Press the button at the desired point. Recording will start. E-36 02/12/18 MDDR470_SEEG_E. fm -Recording from a Microphone- Useful Features " Recording is paused. " "DISCONNECT" will appear for 1 second if nothing is connected. MD-DR470H Recording from a Microphone (continued) To interrupt recording Press the button. " The track number will be increased by one each time the recording is interrupted. ENGLISH !Group-up recording You can shift to group recording whilst recording normally from a microphone. To stop recording Press the button. Press the GROUP button. -Recording from a Microphone- To write recorded contents on the MiniDisc Press the Notes: " Whilst making a mic recording, do not connect anything to the OPTICAL/LINE IN socket on the portable MD. " To use a microphone, be sure it is a plug-in-power type microphone. - When a plug-in-power type microphone is plugged in, the portable MD will provide power for the microphone's operation. - If a different type of microphone is plugged in, it may not operate properly or it may cause the unit to malfunction. " Use a microphone with a 3. 5 mm (1/8") diameter stereo mini plug. Group recording will be activated. Useful Features Press the GROUP button. GROUP1 1 2 1 2 3 A B C D E The track numbers will also be changed. For group recording, see page 14. E-37 02/12/18 MDDR470_SEEG_E. fm MD-DR470H ENGLISH !Sound-actuated recording (Mic Synchronised recording) The unit automatically pauses when the microphone does not pick up any sound for 3 seconds or more. (Pause function does not work for approximately 10 seconds after a recording starts. ) When the microphone picks up sound again, recording starts automatically. Cancel the setting for trace-back recording. 7 8 9 Press the MENU button. The unit enters the menu select mode. Select "SYNC REC" by pressing the or button and press the MENU button. 1 2 Press the REC button. Recording is paused. To perform group recording, hold down the GROUP button for 2 seconds or more so that "GR" is lit. When group recording is not performed, hold down the GROUP button for 2 seconds or more so that "GR" goes out. 3 4 5 6 Press the or level (page 17). button to adjust the recording MIC SYNC H (High): Recording starts when the unit detects -24 dB or more (the unit can start recording from quiet sounds). MIC SYNC L (Low): Recording starts when the unit detects -12 dB or more. " To cancel the operation, press the button. 10When Press the MENU button. The unit enters the menu select mode. a sound, such as person speaking, is picked up by the microphone, recording will begin automatically. Select "REC MODE" by pressing the button and press the MENU button. or Select the recording mode (step 3, page 32) and press the MENU button. Notes: " Synchronised recording cannot be set with traceback recording. " If the unit starts recording from low unwanted noises too often, set the microphone input to "MIC SYNC L (Low)". E-38 02/12/18 MDDR470_SEEG_E. fm -Recording from a Microphone- Useful Features Select the recording start level by pressing the or button and press the MENU button. MD-DR470H Recording from a Microphone (continued) !Track intervals When recording from a microphone, track numbers will be created automatically at regular intervals. Example: Set to "5 minutes". ENGLISH During mic manual recording Timed auto marks will be created every 5 minutes. 1 -Recording from a Microphone- Whilst the recording or recording is paused, press the MENU button. Select "MARK" by pressing the or button and press the MENU button. Select the desired interval by pressing the or button and press the MENU button. OFF TIME 10min TIME 5min TIME 3min No track numbers are created automatically. A new track number is created every 3 minutes. 2 3 Useful Features During mic synchro recording If a silence lasts for 3 seconds or more, a timed auto mark will be created 5 minutes after the previous mark is created. Creating track numbers manually Press the REC button whilst recording. [. . . ] (Shorten the name. ) NO DISC (NoDISC) NO SIGNAL (noSIG. ) " A disc has not been loaded. " No output signal comes out from the connected unit to playback. (Use the AC power for the connected unit. ) " The input signal has improper sampling frequency. " The write protection tab of a MiniDisc is set to the protected position. [. . . ]