User manual SHARP UX-355L

[. . . ] 11. Installation Setting Up and Using OpenLCR Sending Documents Receiving Documents Making Copies Making Telephone Calls Answering Machine Hookup Special Functions Printing Lists Maintenance Troubleshooting open LCR www. OpenLCR. com WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] When the other party answers, pick up the handset to talk. 86 Making Telephone Calls Hold You can put the other party on hold during a conversation by pressing the HOLD/SEARCH key. You can put the handset back in the cradle without breaking the connection. If you did not put the handset back in the cradle, press the HOLD/SEARCH key again to resume conversation. 87 6. Answering Machine Hookup Connecting an Answering Machine If desired, you can connect an answering machine to your fax machine's TEL. This will allow you to receive both voice messages and faxes when you are out. 1 Remove the seal covering the TEL. SET jack. 2 Connect the answering machine's telephone line jack to the TEL. · If desired, you can connect an extension phone to your answering machine's extension phone jack. TEL. To answering machine's telephone line jack. 88 Connecting an Answering Machine Changing the outgoing message The outgoing message (OGM) of your answering machine should be changed to inform callers who want to send a fax to press their Start key. Please leave a message after the beep or press your facsimile Start key to send a fax. Thank you for calling. " Try to keep the length of the message under 10 seconds. If it is too long, you may have difficulty receiving faxes sent by automatic dialing. If your outgoing message must be longer than 10 seconds, leave a pause of about four seconds at the beginning of the message. This will give your fax a chance to detect fax tones sent when automatic dialing is used. Activating the answering machine connection Before you go out, activate the answering machine connection as follows: 1 Set the reception mode to A. M. RECEPTION MODE TEL FAX A. M. 89 7. Answering Machine Connecting an Answering Machine 2 Set your answering machine to auto answer. Your answering machine must be set to answer on a maximum of two rings. If not, you may not be able to receive faxes sent by automatic dialing. If your answering machine has a toll saver function, make sure that it will answer by the fourth ring. Note: If your answering machine has a remote retrieval function, make sure the code used to activate remote retrieval is different from the code used to activate fax reception with an extension telephone (see page 76). If they are the same, entering the code from an outside telephone to retrieve messages will cause the fax machine to be activated. How the connection operates While you are out, all of your incoming calls will be answered by your answering machine and its outgoing message will play. If your fax detects a fax tone or a duration of silence greater than four seconds, it will take over the line and begin reception. When you return and turn off your answering machine, be sure to change the reception mode back to FAX or TEL! 90 Optional A. M. Mode Settings If necessary, you can use the following settings to improve the response of the answering machine hookup to incoming calls. Quiet Detect Time The fax machine is set to take over the line and begin reception if it detects 4 seconds of silence after the answering machine answers. If needed, you can change this setting to any number of seconds from 1 to 10. [. . . ] Regulatory Information NFPA Rating (U. S. A. ) WHMIS Legislation (Canada) Transport Information UN No. : : : : No information Not controlled No information No information Section 11. Other Information References : IARC(1996), IARC Monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol. 65, Printing Process and Printing Inks, Carbon Black and Some Nitro Compounds, Lyon, pp-149-261 H. [. . . ]