User manual SHARP XE-A403

[. . . ] ELECTRONIC CASH REGISTER CAJA REGISTRADORA ELECTRONICA MODEL MODELO XE-A403 INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES WARNING FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] Turn the mode switch to the REG position with the power cord connected. Press the } key to advance the journal paper until its printed part is out of the way. 4. Press the } key until the paper remaining in the printer comes out completely. 7. Remove the paper roll from the paper roll cradle of the journal side. Do not pull the paper through the printer. 65 8. Remove the outer side of the take-up spool as shown on the left. 9. Remove the printed journal roll from the take-up spool. Installing the paper roll Caution: The paper cutter is mounted on the printer (receipt side). Turn the mode switch to the REG position with the power cord connected. Insert the end of the paper into the paper chute of the printer until it is caught by the printer auto-feed and comes out of the top of the printer. If the printer does not catch the paper, feed the paper while pressing the key. Cut off the excess paper using the paper cutter, and replace the printer cover. Turn the mode switch to the REG position with the power cord connected. Insert the end of the paper into the paper chute of the printer until it is caught by the printer auto-feed and comes out of the top of the printer. If the printer does not catch the paper, feed the paper while pressing the key. Set the spool on the bearing, and press the key to take up excess slack in the paper. Replace the printer cover. } } } When you want to manually install a new roll of paper while the machine is turned off, follow the steps shown below: 1. Pull the print head release lever toward you (to the head-up position). Correctly place the new paper roll into the paper roll cradle of the receipt/journal side. Insert the paper end into the printer until it comes out of the printer. Return the print head release lever to its original position. 66 5 Removing a Paper Jam Caution: The paper cutter is mounted on the printer (receipt side). Never touch the print head immediately after printing, because the head may still be hot. 1. Pull the print head release lever all the way forward (after it stops at one position, continue pulling forward until it stops again and cannot be pulled forward any further). Check for and remove any shreds of paper that may remain in the printer. [. . . ] SUBIDO NO HAY PAPEL Estado de error Error de registro Error de operación incorrecta Se ha introducido un código no definido. La memoria está llena (en la programación de la tecla a). Pulsación obligatoria de la tecla s para finalización directa Importe recibido obligatorio Falta el registro de un código de dependiente. Error de límite de rebose La entrada de precio abierto está inhibida. [. . . ]