User manual SHARP XL-S10

[. . . ] To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. MICRO COMPONENT SYSTEM MODEL XL-S10 Micro Component System consisting of XL-S10 (main unit) and CP-S10 (speaker system). XL-S10 OPERATION MANUAL XL-S10 SPECIAL NOTES NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The new tracks will be stored after the last track of the original program. Opening the CD compartment automatically cancels the programmed sequence. Even if you press the ON/STAND-BY button to enter the stand-by mode or the function is changed from CD to some other function, the programmed selections will not be cleared. During program operation, random play is not possible. 17 CD Playback XL-S10 Listening to the radio 1 2 Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "FM" or "AM" appears on the display. When operating with the remote control, press the TUNER (BAND) button to select "FM" or "AM". Manual tuning: Press the TUNING button as many times as required to tune in to the desired station. Auto tuning: When the TUNING button is pressed for more than 0. 5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station. When radio interference occurs, auto scan tuning may stop automatically at that point. To stop the auto tuning, press the TUNING button again. 3 Radio To receive an FM stereo transmission: Press the FUNCTION (TUNER (BAND)) button to display the "ST" indicator. If the FM reception is weak, press the FUNCTION (TUNER (BAND)) button to extinguish the "ST" indicator. FM stereo mode indicator After use: Press the ON/STAND-BY button to enter the power stand-by mode. FM stereo receiving indicator 18 Listening to the memorized station " Memorizing a station You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning) XL-S10 " To recall a memorized station Press the PRESET ( or ) button for less than 0. 5 seconds to select the desired station. 1 2 3 Perform steps 1 - 3 in "Listening to the radio" on page 18. Press the MEMORY/SET (MEMORY) button to enter the preset tuning saving mode. Within 5 seconds, press the PRESET ( or ) button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1. Within 5 seconds, press the MEMORY/SET (MEMORY) button to store that station in memory. If the "MEMORY" and preset number indicators go out before the station is memorized, repeat the operation from step 2. Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorized will be erased. Preset channel Frequency and frequency band " To scan the preset stations The stations saved in memory can be scanned automatically. (Preset memory scan) 1 2 Press the PRESET ( station is located. or ) button again when the desired 5 " To clear a memorized station 1 2 3 Recall the memorized station. [. . . ] After long use, the deck's heads and capstan may become magnetized, causing poor sound. Demagnetize these parts once every 30 hours of playing/recording time by using a commercial tape head demagnetizer. Read the demagnetizer's instructions carefully before use. 29 References XL-S10 Specifications As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. [. . . ]