User manual SHARP XLHF202PHX OPERTIONMANUAL

[. . . ] — For device with a lower Android version, refer the operation manual of the device for recommended app (application). Pdf ● Hereby, SHARP Electronics declares that this SHARP Hi Fi Component System XL-HF202PH(S)/XL-HF202PH(BK)/XLHF302PH(T) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. — When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still present inside the unit. When the ON/STAND-BY button is set at STAND-BY position, the unit may be brought into operation by the timer mode or remote control. [. . . ] —● If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. —● Be sure to place 8 cm (3”) disc in the middle of the disc tray. —● Due to the structure of the disc information, it takes longer to read an MP3/WMA disc than a normal CD (approximately 20 to 90 seconds). Note for CD or MP3/WMA disc: ●● Rewritable multi-session discs with unfinished writing, can still be played. –■ Direct track search Use the Numeric buttons (remote control) to select the desired track while playing the selected disc. —● When selecting number 10 or higher, use the “10+” button. For example, to choose 130 1 Press the “10+” button twice. Notes: ●● A track number higher than the number of tracks on the disc cannot be selected. –■ Random play To random play all tracks: Press RANDOM button on the remote control until “Random” appears. Notes: ●● If you press the button during random play, you can move to the track selected next by the random operation. —● In random play, the unit will select and play tracks automatically. ) E-12 Listening to a CD or MP3/WMA disc (continued) ■■ Repeat play Repeat play can play one track, all tracks or a programmed sequence continuously. Press the REPEAT button repeatedly until “Repeat One” appears. To repeat all tracks: Press the REPEAT button repeatedly until “Repeat All” appears. To repeat desired tracks: Perform steps 1 - 5 in “Programmed play” section on this page and then press the REPEAT button repeatedly until “Repeat All” appears. To repeat one folder: While in Folder mode on (MP3/WMA), press REPEAT button repeatedly until “Repeat Folder” appears. To cancel repeat play: Press the REPEAT button repeatedly until “Normal” appears and “ ” disappears. To cancel the programmed play mode: During programmed stop mode, press the (CD ) button. The display will show “Memory Clear” and all the programmed contents will be cleared. Adding tracks to the programme: If a programme has been previously stored, the “MEM” indicator will be displayed. Notes: ●● When the disc compartment is opened, the programme is automatically cancelled. —● If you press the ON/STAND-BY button to enter the stand-by mode or change the function from CD to another, the programmed selections will be cleared. [. . . ] –■ Condensation Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet (CD pickup, etc. If this happens, leave the power on with no disc in the unit until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit. ■■ CD player Possible cause ●●The disc is loaded upside down. [. . . ]