User manual SHIMANO BR-5700 MOUNTING

[. . . ] Because each bicycle may handle differently, be sure to learn the proper braking technique (including brake lever pressure and bicycle control characteristics) for your bicycle. Consult your bicycle dealer and the bicycle's owners manual, and practice your riding and braking technique. · If the front brake is applied too strongly, the wheel may lock and the bicycle may fall forward, and serious injury may result. [. . . ] If any oil or grease do get on the shoes, you should replace the shoes, otherwise the brakes may not work correctly. · Check the brake cable for rust and fraying, and replace the cable immediately if any such problems are found. · Always make sure that the front and rear brakes are working correctly before you ride the bicycle. · The required braking distance will be longer during wet weather. To avoid this, reduce your speed and apply the brakes early and gently. · Read these Technical Service Instructions carefully, and keep them in a safe place for later reference. Tape Toe-in 0. 5 mm Installation of the brake lever 1. Installation to the handlebar Move the bracket cover forward, and then securely tightening the mounting nut with a 5 mm Allen key. Bracket cover Then wrap the handlebar with handlebar tape. Note: The BR-5700 allows the angle of contact between the shoe and the rim (toe-in) to be adjusted. Adjusting the toe-in makes it possible to obtain smoother braking operation. Depress about 10 times Note: Cut the cable at the length at which it is not pulled tight when the handlebar is turned all the way to the left and right. 3. Install the name plate. Hollow Tightening torque: 0. 15 - 0. 2 N·m {1. 3 - 1. 8 in. Lever stroke adjustment (ST-5700/5703) If you would like to make the lever stroke smaller, install the accessory pad spacer. Check the brake operation while adjusting. 4 mm Allen key Shoe fixing bolt 5 mm Allen key Tightening torque: 5 ­ 7 N·m {43 ­ 61 in. lbs. } The correct way for clamp washer (B) to face is so that the small hollow on the surface is in the top-left corner. Fixing bolt Tightening torque: 6 ­ 8 N·m {52 ­ 69 in. Cable connection Set the quick release lever to the closed position; then adjust the shoe clearance (as shown in the illustration below) and secure the cable. Cable bolt tightening torque: 6 ­ 8 N·m {52 ­ 69 in. lbs. } When installing the components to carbon frame/handle bar surfaces, verify with the manufacturer of the carbon frame/parts for their recommendation on tightening torque in order to prevent over tightening that can cause damage to the carbon material and/or under tightening that can cause lack of fixing strength for the components. 2. Remove the shoe by sliding it along the groove of the shoe holder. Shoe 2. Centering of the brake shoe Make a minor adjustment by using the centering adjustment screw. 3. [. . . ] lbs. } 5 mm Allen key Closed Quick release lever Fixing screw Shoe insertion direction Fixing screw Pass the inner cable through as shown in the illustration, and then set the inner cable drum into the cable hook. Cable hook 4. Tighten the fixing screw. Inner cable drum Tightening torque: 1 ­ 1. 5 N·m {9 ­ 13 in. Readjustment of the shoe clearance Turn the cable adjustment bolt to readjust the shoe clearance. [. . . ]