User manual SIEMENS LB54564GB

[. . . ] If no activated carbon filter is installed, it is not possible to bind the odorous substances in the cooking vapours. Circulating-air mode An activated carbon filter must be fitted for this operating mode (see Filters and maintenance). Activated carbon filters can be purchased from specialist outlets (see Optional accessories on the last page). The ventilator fan draws the vapours produced during cooking into the extractor hood, where they pass through the grease filter and the activated carbon filter before the clean air is discharged back into the kitchen. The grease filter absorbs the grease contained in the vapours produced during cooking. [. . . ] In so doing you will be ensuring that the extractor hood performs as effectively as possible. Remove the wire grille and replace the filter mat. Removing and installing the grease filter Extractor hoods with a filter mat: 1. The left and right sides of the filter frame must lock into position! 5 Filters and maintenance Extractor hoods with two filter cartridges: Warning: The halogen bulbs must be switched off and cool. Depress the detent on the grease filters in the direction of the arrow and fold down the grease filter slightly. Detach the grease filter by pulling it towards yourself. Activated carbon filter Removing and installing the activated carbon filter Extractor hoods with a filter mat: 1. The wire grille is no longer required when an activated carbon filter is installed. 2. Place the activated carbon filter on the filter mat and clamp it in. 2. 6 Activated carbon filter Extractor hoods with two filter cartridges: 1. Insert the screw through the wing nut and the sleeve and screw in the middle screw in the false bottom (required only during the initial installation). Screw, sleeve and wing nut are enclosed with the activated carbon filter. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. Tape over the activated carbon filter with the enclosed sealing strip. 6. Removing the activated carbon filter: The activated carbon filter is removed in reverse sequence. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. as residual waste. 7 Cleaning and care Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. At the same time as you renew the grease filter (see Filters and maintenance), clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Clean the extractor hood with a hot detergent solution or a mild window cleaning agent. If the hood is extremely dirty (older stains), use a liquid window cleaner. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. [. . . ] Disconnectors are switches with a contact opening of more than 3 mm and all-pole disconnection. If the connection cable of this appliance is damaged, it must be replaced by the manufacturer, his customer service or a similarly qualified person in order to prevent a hazardous situation. Electrical specifications: The electrical specifications can be found on the rating plate inside the appliance when the filter frame has been removed. This appliance complies with the EC radio interference suppression regulations. Installation The extractor hood is particularly suitable for installation in a flue or chimney. [. . . ]